Flextronics 52192780 User manual

27755 Stansbury St #300 | Farmington Hills, MI 48334 | USA | main: +1 248 853-5724

Date: August 9, 2021

User Manual Information for Flex Wireless Charging Pad Module

Flex Automotive USA Inc

27755 Stansbury Blvd, Ste 300

Farmington Hills, MI 48334, USA

Vehicle Manual

The Flex product Wireless Charging Pad Module (WCPM) will be provided directly to the vehicle

manufacturer and not to an end-user. The vehicle manufacturer will assemble the WCPM as part of the

vehicle. Therefore, Flex will not be supplying an end-user manual. Flex has provided the following text to

vehicle supplier for their consideration to be included in their vehicle’s manual.

FCC ID: 2AF5R-52192780

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device

may not cause harmful interference, and (2) this device must accept any interference received, including interference

that may cause undesired operation.

To ensure compliance with FCC RF exposure requirements this device must be installed to provide a minimum of 20cm

between the device and people.

Vehicle Installation

The WCPM is permanently installed into the front center console area in an automotive vehicle and is

only removable by a qualified service technician. The WCPM is not designed to be operation outside of

the vehicle. The WPCM mounts on the back side of the A-surface using four screws and designed to

connect to the vehicle wire harness and draw power from vehicle battery. LIN bus communications on

the vehicle bus harness are required for the WPCM to operate.