2. 3SIXT
  3. Apple SmartWatch Band
Apple SmartWatch Band

3SIXT Apple SmartWatch Band Operating instructions

  • Hello! I've reviewed the user manual for Apple Watch band replacement and I'm ready to answer your questions. The document provides a guide on how to correctly remove old bands and install new bands, with a focus on ensuring the bands are properly secured for safe use.
  • How to prepare my Apple Watch for band replacement?
    Where are the band release buttons located?
    How do I remove the old band?
    How do I install a new band?
    What if the band moves freely after installation?
Prepare a clear flat surface on which to lay out a clean,
so cloth to rest your Apple Watch face on (like a
microfibre cloth or towel) and place your Apple Watch
face-down on the surface.
Locate the two band release buons on the back of
your Apple Watch.
Hold down one the band release buon, then slide the
relevant band across to remove it.
You should not need to force the band into the slot.
You can slide the band le and right in the slot until
you hear or feel the band click into place.
When the band is correctly installed, it will not freely
move until you hold down the band release buon. If
the band is moving freely and is incorrectly installed,
do not wear the watch, the band could fail, and you
may damage or lose your Apple Watch.
If the band doesn’t slide out, press the band release
buon again and make sure that you hold it down.
Repeat for the other band.
Ensure you have the back of the band facing you, then
slide the new 3SIXT band in until a click is heard or
felt (you do not need to hold down the band release
buon to complete this step).
BAND RELEASE BUTTONS
SLIDE OUT
SLIDE IN
/