4.2.1 Press and hold the "X" + "HOME" key of the handle at the same time, and release the hand when the RGB red light
of the handle flashes.
4.2.2 Open Bluetooth search of Android device and click "PXN-P6A" to pair.
4.2.3 The connection is successful, and the RGB red light of the handle is always on.
4.3 Android Bluetooth Direct connection:
4.3.1 Press and hold the "A" + "HOME" key of the handle at the same time, and release the hand when the RGB blue light
of the handle flashes.
4.3.2 Open Bluetooth search of Android device and click "PXN-P6a" to pair.
4.3.3 The connection is successful, and the RGB blue light of the handle is always on.
4.4 Bluetooth IOS Connection:
4.4.1 Press and hold the "B" + "HOME" key of the handle at the same time, and release the hand when the RGB green light
flash on the handle.
4.4.2 Open Bluetooth search of Android device and click "PXN-P6M" to pair.
4.4.3 The connection is successful, and the RGB green light of the handle is always on.
4.5 PC Receiver Connection:
4.5.1 Insert the Nano receiver into the USB port of your computer,
4.5.2 Long press the "START+HOME" button for 3 seconds when the controller is off, and the white light of the controller
flashes.
The green LED is always bright after successful connection.
4.5.3 In PC belongs to X-INPUT mode key value.
4.6 PC Wired Connection:
4.6.1 Connect the handle to the computer with a USB cable, and the handle will be automatically recognized as Xinput
mode.
4.6.2. The RGB green light of the connected handle is always on.
4.6.3 Because the data cable is used, the handle will be charged, so the cable is connected to the computer
The green light blinks slowly.
5. functional description：
5.1 Reset Function:
When the handle appears dysfunctional, crash or other abnormalities, you can press the switch in the back reset hole of
the handle, the opponent
The handle is reset and shut down, and then press "HOME" button on the handle to restart the connection and pairing.
5.2 Description of Special Functions:
5.2.1 Low power: The red LED flashes when the battery voltage is lower than 3.7V, and turns off when the battery voltage is
lower than 3.5V
The handle
5.2.2 Sleep: the handle is not connected within 1 minute and enters the sleep state; When the handle is in working
condition, it will go to sleep for 5 minutes without any button or axis action; In the sleep state, press the "HOME" key to
wake up, and automatically connect back to the mode before shutdown. The sleep current is less than 50uA.
5.2.3 Charging: Charging voltage :USB5V. The handle can be charged through USB ports such as mobile phone charger,
computer and TV.
The handle should be fully charged for 2-3 hours.
Charging indication: The mobile phone charger will flash with white light (change to red light after one minute), and the
computer will flash with green light when it is full
The lights go out.
5.2.4 Calibration function: Press the HOME button once when the controller is off, and press the BACK+RB key (RGB) at the
same time after the controller is turned on
The light will shine alternately. Press the left trigger, the right trigger, the left rocker, the right rocker several times, and
press BACK+ right at the same time
