Econoco PSC2 Installation guide

Brand
Econoco
Model
PSC2
Type
Installation guide

This manual is also suitable for

- SCREW THE FACE OUT INTO THE
TOP UPRIGHT.
- SCREW THE LOWER UPRIGHT
INTO THE TOP UPRIGHT.
NOTE:
BE SURE THE CLEARANCE
HOLE ON THE BOTTOM UPRIGHT
IS CLOSE TO THE UNION ON THE
TOP UPRIGHT.
FACE
OUT
BOTTOM
UPRIGHT
TOP
UPRIGHT
CLEARANCE
HOLE
UNION
- TO TIGHTEN THE UPRIGHT
COMPONENTS TOGETHER, INSERT A
SCREWDRIVER, OR SIMILAR TOOL,
THROUGH THE CLEARANCE HOLE IN
THE BOTTOM UPRIGHT.
- USING THE FACE OUT AND
SCREWDRIVER FOR LEVERAGE,
TIGHTEN THE UPRIGHTS TOGETHER
AS MUCH AS POSSIBLE.
NOTE:
THIS STEP MAY REQUIRE 2
PEOPLE.
BASE
SET SCREW
- INSTALL THE CASTERS INTO THE
PIPE BASE.
- SCREW THE ASSEMBLED UPRIGHT
INTO THE BASE.
NOTE:
MAKE THE UPRIGHT AS
TIGHT AS POSSIBLE WHILE ALSO
ALIGNING THE FACE OUT SO IT IS
PARALLEL WITH THE BASE.
- INSTALL THE BASE SET SCREW AS
SHOWN UNTIL IT IS TIGHT.
ATTENTION
BEFORE BEGINNING ASSEMBLY, INSPECT THE
BASE 3-WAY PIPE FITTING TO SEE IF THE UPRIGHT
SET SCREW IS INSTALLED FROM THE FACTORY. IF
IT IS, BE SURE TO UNSCREW IT AS FAR AS
POSSIBLE, OR REMOVE IT. IF IT IS PACKED
SEPARATELY, IGNORE THIS STEP.
2
SHEET 1 OF 1
PSC2
3
4
1
  • Page 1 1

Econoco PSC2 Installation guide

Brand
Econoco
Model
PSC2
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents