Installing the Glass Canopy
LAM2604
LAM2605
LAM2606
Circular Island
Extrac
With Glass
tor
Installing the glass canopy
o Carefully turn the appliance upside down,
so that the grease filter is pointing upwards to
the ceiling.
o Remove the fixing screw that holds the
grease filter in place and then pull away the
grease filter from the cooker hood.
o Use a screwdriver to remove the 4 fixing
screws that hold the base of the cooker hood in
position.
o Remove the 2 screws in the light wiring
connection box that is situated inside of the
hood.
o Remove the
base of the cooker hood by pulling it upwards and away
from the main body of the hood.
o Open the cover of the light wiring point that is situated inside of the
hood and then pull apart the wires that are inside.
o Discard the black plastic ring.
o
Place the metal ring on the main body of the hood ensuring that the
slots on the ring fit into the corrosponding slots on the main body.
o Carefully lift the glass canopy towards the
main body of the hood.
o C
Ensure that the slots in the metal ring line up with the slots in the
top section of the extractor.
arefully locate the glass canopy over the main body of the hood.
o Push together the wires inside of the light wiring point. Retighten
the screws for the light wiring point inside of the cooker hood.
o Place the base of the cooker hood back onto the main body of the
hood.
o Use a screwdriver to retighten the 4 fixing screws that hold the base
of the cooker hood in position.
o IMPORTANT: These screws MUST be fully tightened.
v2 30-01-2015
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Baumatic PV372SS User manual
-
-
Zanussi ZHC945X/GB User manual
-
Tricity Bendix CH950X User manual
-
Baumatic BTI9170GL User manual
-
Baumatic btc 9750 gl Owner's manual
-
Euromaid CP9BLB User manual
-
Baumatic LIH9026G User manual
-
Baumatic BT06.7ME User manual
-
