Summit TD15SD, TD24 Installation guide

Hello! I'm your chat assistant, and I've reviewed the user manual for the Summit Storage Drawer models TD15SD, TD24, and TD24SD. This manual provides step-by-step instructions on how to install the drawer on top of your refrigerator and describes how to attach custom panels to the front of the drawer. I'm ready to answer any questions you have about the installation or features mentioned in the document.
What is included in the kit?

What should I avoid during installation?

Can I install a custom panel on the drawer?

Summit Appliance Division · Felix Storch, Inc. · www.summitappliance.com · 718-893-3900 · info@summitappliance.com

Installing Your Slide-Out Storage Drawer

SKUs: TD15SD, TD24, TD24SD

This drawer can be installed on top of your refrigerator to provide extra non-refrigerated storage.

WARNING:

DO NOT DRILL INTO YOUR REFRIGERATOR WHEN INSTALLING THIS DRAWER

Some refrigerators have electrical or refrigerant lines on the top, and you can ruin yours.

INSTRUCTIONS

1. Gather and identify all parts.

2. Peel off the protective film covering the drawer.

3. Place the drawer on top of your unit. Make sure it perfectly aligns on all sides.

4. Peel the protective layer off the L-bracket’s adhesive strips.

5. Align one side of the L-bracket on the rear of the refrigerator and the other over

the rear lip of the drawer assembly

6. When aligned completely, peel the tape from the adhesive strip on the rear and

top and press into place.

INSTALLING A PANEL ON YOUR DRAWER (OPTIONAL)

This drawer is designed to accept custom overlay panels on its front.

INSTRUCTIONS

1. Remove the knobs from the drawer by unscrewing the screws behind the

drawer’s front.

2. Attach your own handle to the panel’s face.

3. Place your custom panel over the drawer front and align carefully.

4. Using the screw holes from the removed knobs, attach the panel by holding it

in position and inserting two wood screws (not provided) from the rear.

Panel Dimensions:

Drawer Front: 2” H x 14 14

⁄ " W (TD15 models)

2” H x 23 14

⁄” W (TD24 models)

Thickness should match your cabinet fronts.

Align L-bracket over the drawer

and flush with the appliance’s rear

INCLUDED IN THIS KIT

▪ 1 L-Bracket (with adhesive strips already

attached)

▪ 1 Slide-Out Storage Drawer

▪ 1 Instruction Manual