2. Vehicles & accessories
  3. Motor vehicle electronics
  4. Car speakers
  5. OWI
  6. AMP6022W

OWI AMP6022W, AMP602B Owner's manual

  • Hello! I've read the user manual for the OWI speakers, including models AMP602-2W, AMP602-2B, AMP602W, AMP602B, V-ST602BA, AMP602 and P602. This manual provides detailed information on installing and wiring these amplified and non-amplified speakers, along with their technical specifications. They feature a two-way design with a built-in amplifier. Feel free to ask me any questions you have about the features or setup.
  • What type of speaker design is used?
    What is the size of the woofer?
    What is the frequency response of the speakers?
Established 1978
OWI Incorporated
R
MODEL:V-ST602BAMODEL:V-ST602BA
OUTPUTOUTPUT
RR RR
MODEL:V-ST602BAMODEL:V-ST602BA
PUBLIC ADDRESS RADIO,AUDIO,VCD,DVD,LDPUBLIC ADDRESS RADIO,AUDIO,VCD,DVD,LD
LINE OUTLINE OUT
ININ
OUTOUT
LIN ELIN E
AMP602W
AMP602B
AMP602W
AMP602B
2-Way Plastic Vented BOX Design
With Built-in AMPLIFIER
2-Way Plastic Vented BOX Design
With Built-in AMPLIFIER
6-1/2" Mica Cone Rubber Edge Woofer
0.79"(20mm)PEI Dome Tweeter
Rms Output Power:2x15Watts
Frequency Respone:80Hz-20kHz
Establ is he d 19 78Establis he d 19 78
OWI In co rpor atedOWI In co rpor ated
RR
Establ ish ed 197 8Establ ish ed 197 8
OWI In corp orat edOWI In corp orat ed
RR
P6 02W
AMPLIFIED SURFACE MOUNT SPEAKER COMBINATION
Model AMP602-2W & AMP602-2B
WIRING INSTRUCTIONS
WIRING INSTRUCTION
AMP602
Amplified Speaker
P602
Non-amplified Speaker
(Please see mounting instructions on the reverse side)
OWI Incorporated * 17141 Kingsview Ave.Carson CA 90746-1207 USA * Tel.310-515-1900 * Fax 310-515-1606
SPECIFICATIONS
Info owi-inc.com * www.owi-inc.com
@
OWI Inc. * 17141 Kingsview Ave. Carson, CA 90746 USA * Tel. 310-515-1900 * info@owi-inc.com * www.owi-inc.com
INSTALLATION INSTRUCTIONS
AMP602-2W & AMP602-2B
1) When mounting speakers, use the mounting bracket as a template for marking and drilling three holes.
2) Assemble mounting screws, spring washers, flat washers and nuts to attach mounting brackets to mounting
surface. Note that:- Screws, washers and nuts provided are for mounting the cabinet from both sides of the
mounting location. For any other type of mounting, please consult your local hardware store for appropriate
mounting screws.
3) Follow installation directions included with your amplifier (or receiver). Strip 1/2" (12mm) of insulation
from each of the two conductors of the wire to expose the bare metal and twist each into a single strand.
[Connect the speaker wire to the terminals using the (+) as RED and the (-) as the BLACK].
4) Adjust position of the speaker to obtain the desired sound dispersion.
PARTS INCLUDED:
Mounting bracket 2 each
Bracket knob 4 each
Mounting screw 4 each
Flat washer 4 each
Speakers 2 each
/