Rhino-Rack JA9809, JA9810, Vortex 2500 2 Bar FMP Roof Rack Installation guide

  • Hello! I have examined the installation instruction for the RHINO-RACK Crossbar RS DK478. This document provides detailed step-by-step instructions for installing the crossbar on a Jeep Renegade Sport 4dr SUV, including how to identify mounting points, modify the ditch mold, and ensure proper measurements. I'm here to answer your questions about the installation process and the features of the device.
  • What vehicle is this crossbar installation instruction for?
    What is the measurement for the front crossbar strip length per side?
    What is Measurement A?
DK478 VA, Euro, HD, RS Crossbar instruction
Document No. R1585 Issue 1: 05 October 2017 Page 1 of 1
Vehicle Date Crossbar Front
Pad
M6 Stud
length
(mm)
M6 Screw
length
(mm)
Measurement
strip length
per side
Measurement
strip length
per side
Measurement
Distance
( x )
Foot plate
arrow
direction
Rear
Pad
M6 Stud
length
(mm)
M6 Screw
length
(mm)
Measurement
strip length
per side
Measurement
strip length
per side
Measurement
Distance
( x )
Foot plate
arrow
direction
Jeep
Renegade
Sport 4dr
SUV
15- 1375mm M473 30 35 108mm N/A 979mm /
38,9/16” OUT M473 30 35 98mm N/A 959mm /
37,3/4” OUT
FRONT REAR
VAVA HDHD EUROEURO
Measurement A: _____________
Measurement B: _____________
270mm -10 5/8”
Crossbar Identication Crossbar Identication
A
B
910mm - 35 13/16”
```
1
FRONT REAR
Remove the ditch mould and lay it beside the ditch
upside down. Identify the spots in the mould that sit
above the mounting points front and rear.
```
2Drill through these points to
allow the stud to pass, when
the mould is reinstalled.
12mm / 1/2”
CONTROLLED
/