OMIX 19101.03 Installation guide

  • Hello, I am an AI assistant, and I have reviewed the provided installation instructions for the Wiper Motor Kit models: 19101.03, 19101.02, and 19101.04. This document includes information about the wiring of the different terminals and fuse usage. I am ready to answer your questions.
  • Where should the 'S' terminal be connected?
    Where should the '-' terminal be connected?
    Where should the '+' terminal be connected?
    What type of fuse should be used?
WIPER MOTOR KIT INSTALLATION INSTRUCTIONS
P/N: 19101.03 (12V-ST) 12Volt Stainless Steel
19101.02 (12V) 12 Volt Kit - Black
19101.04 (24V) 24 Volt Kit Black
Installation Notes: The S terminal should be connected to one side of
the control switch. The other lead wire from the
switch will need to be grounded.
The terminal should be connected to a good
ground on the vehicle chassis or to the batterys
negative terminal.
The + terminal should be connected to the original
fused wiper motor wire or fused battery positive
wire. Use a 10amp fuse if a new wire assemble is
to be used.
Date: 5/19/06
/