American Standard 9075.120 User manual

Brand: American Standard

Model: 9075.120

Type: User manual

This manual is also suitable for

H35

SAVONA™

WHIRLPOOL

HIGH GLOSS

SAVONA™ WHIRLPOOL

❏ 2901.028WC Whirlpool featuring System II

• Acrylic with berglass reinforcement

• EverClean

System

• Pre-leveled tub bottom

• Two person design with center drain and dual

lumbar ends

• Dual, molded-in arm rests

• Faucet deck/accessory area

• 2.1 HP two speed, self-draining pump/motor

with pulse feature

• Factory installed power cord with plug

• Ten multi-directional and ow-adjustable

jets including:

- Two Ideal-ow jets

- Six body massage jets

- Two recessed back-rest jets

• Deck-mounted, electronic control with 20

minute built-in timed safety shut off and

Chrome bezel

• Three silent air volume controls

• Quick Connect Safe-T-Heater

connection system

• Factory installed and tested whirlpool system

Nominal Dimensions:

1810 x 1105 x 559mm

(71-1/4" x 43-1/2" x 22")

Compliance Certications -

Meets or Exceeds the Following Specications:

• Underwriters Laboratories - Hydromassage

Bathtubs UL 1795

• ASME A112.19.7M for Whirlpool Appliances

• ANSI Z124.1 for Plastic Bathtubs

• ASTM E162 for Flammability

• NFPA 258 for Smoke Density

American Standard whirlpools and air baths with

EverClean

incorporate a patented silver-ion

additive right into the circulation piping to protect

the pipes from mold, mildew, algae and fungus that

could cause deterioration or staining of the pipes.

SEE REVERSE FOR PRODUCT DIMENSIONS

AND SPECIFICATIONS

Revised 2/08

To Be Specied - Required:

❏ Color: (specify color)

❏ Bath Faucet: (specify nish)

❏ Rotary Drain: 1583.470 (specify nish)

To Be Specied - Optional:

❏ Safe-T-Heater*: 9075.120

❏ System II Control Bezel: 9861.100 (specify nish)

For color/nish availability and other faucet choices, please

see the Product Selector and Pricing Guide.

* NOTE: the Safe-T-Heater is designed to maintain water

temperature during operation. It will not heat cold water to

desired bathing temperature.

H36

SAVONA™

WHIRLPOOL

HIGH GLOSS

NOTES:

BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND OR PENINSULA TYPE INSTALLATION. SUMP

OF BATH IS SUPPORTED BY INTEGRAL FEET. NO ADDITIONAL SUPPORT REQUIRED. ENCLOSING MATERIALS BY OTHERS.

● IF INSTALLING A DECK-MOUNTED FITTING, BEFORE DRILLING ANY HOLES: CHECK FOR INTERFERENCE WITH CIRCULATING

SYSTEM PIPING AND DRAIN OVERFLOW. MOUNTING HOLES DRILLED BY INSTALLER.

OPTIONAL TILING BEAD KIT AVAILABLE.

■ REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.

FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.

PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.

ON SYSTEM II: CONTROL MODULE TO BE MOUNTED BEHIND ACCESS PANEL, A MINIMUM OF (152mm) 6 ABOVE ROUGH FLOOR.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1 / CSA

Certied. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided leaet.

ON/OFF

SWITCH

1810mm

(71-1/4)

905mm

(35-5/8)

C/L

19mm

(3/4)

TYP.

1105mm

(43-1/2)

552mm

(21-3/4)

305mm

(12)

140mm

(5-1/2)

508mm

(20)

559mm

(22)

178mm

(7)

OUTLINE OF

1772mm X

1067mm

(69-3/4 X 42)

CUTOUT

PUMP

PROVIDE ACCESS

TO PUMP FOR SERVICE

ON ALL INSTALLATIONS

229mm X 305mm

(9 X 12) FLOOR

CUTOUT

RECOMMENDED

FITTING LOCATION

64 X 279mm (2-1/2 X 11)

C/L OF 1-1/2 O.D.

DRAIN OUTLET

C/L OF OVERFLOW

51mm

(2)

38mm

(1-1/2)

89mm

(3-1/2)

LEVELING STRINGER

NOT FOR SUPPORT

ROUGH

FLOOR

1-1/2 O.D. TAILPIECE

INTEGRAL

FEET

89 mm

(3-1/2)

44 mm

(1-3/4)

1-1/2 N.P.T.M.

THREADS

SAFE-T-HEATER

REMOVABLE

BLANK

GENERAL SPECIFICATIONS FOR 2901 WHIRLPOOL

71-1/4 x 43-1/2 x 22 In.(1810 x 1105 x 559mm)

152 Lbs. (68 Kg.)

936 Lbs. (421 Kg.)

94 Gal. (356 L)

86 Gal.(326 L)

44 x 28 In. (1118 x 711mm)

67-1/2 x 33 In. (1715 x 838mm)

16-1/4 In. (413mm)

43 Lbs./Sq.Ft. (211 Kgs./Sq.m)

27.8

61.5

INSTALLED SIZE

WEIGHT

WEIGHT w/WATER

GAL. TO OVERFLOW

WHIRLPOOL MIN. OPERATING VOL.

BATHING WELL AT SUMP

BATHING WELL AT RIM

WATER DEPTH TO OVERFLOW

FLOOR LOADING

(PROJECTED AREA)

PTS.

CUBE (FT

)

WHIRLPOOL ELECTRICAL SPECIFICATIONS

2.1 HP, 15.6 AMPS, 120V.SYSTEM II PUMP

Revised 2/08

American Standard 9075.120 User manual

Brand: American Standard

Model: 9075.120

Type: User manual

This manual is also suitable for

Download PDF

report

American Standard 9075.120 User manual

This manual is also suitable for

American Standard 9075.120 User manual

Related papers