SZSAGO W5S-GREY User guide

Brand
SZSAGO
Model
W5S-GREY
Type
User guide
Binaural Wireless Bluetooth Earbuds
User’s Guide
Illustration Using W5S Earbuds
Packing List
Bluetooth Earbuds*2
Charging Case
User’s Guide
Micro USB Cable
Eartips*3
Product Parameter
Multifunction key
LED indicator
Charging case
1.BT Version: BT5.0
Eartips can be replace
Pair them with your device
Charge
Use a charger under 5V/2A to charge charging case
Turn them on
Wear your W5S earbuds How to charge
When charging case is charging, the indicator flash red all the
time; when fully charged, the indicator flash blue then lights off after
about 60 seconds. ( Earbuds and charging case can be charged
simultaneously)
When the earphone is charging, the right earphone is placed in
the charging case, and the indicator light on the right side of the
charging case flash red. After the charging case is full, the right
indicator light of the charging case flash blue, and the indicator
light will be off in 3 minutes, then entering the pairing mode.
When the earbuds is fully charged, it will automatically connect to
the mobile phone. If it is not found mobile phone, after 3 minutes,
the Bluetooth headset will automatically shut down.
When the earphone is charging, the left earphone is placed in
the charging case, and the indicator light on the left side of the
charging case flash red. After the charging case is full, the left
indicator light of the charging case flash blue, and the indicator
light will be off in 3 minutes, then entering the pairing mode.
The indicator light in the middle of the charging case flash blue
light when 30%-100% of the battery; it flash red when the battery
is less than 30%; when the charging case will deplete, the middle
indicator quickly flashing for 5 minutes.
When the charging case is charging the earphone, the left
indicator light controls the charging state of the left earphone; the
right indicator light controls the charging state of the right earphone.
The charging case will automatically turn off when it is not
working for 15 seconds.
Instruction
LED Indicator
Charge
Charging
Flashing Red
Fully Charged
Steady Blue
Charging
Flashing Red
Fully Charged
Steady Blue
W5S pairing instructions (binaural mode)
charging case to charge the earbuds
Monaural Mode
Long press the earphones for about 3 seconds until the voice
prompts "du" to switch songs(left is the previous song,right is the
next song)
Step 1: open the charging case
Step 2: Take out of them from charger case, one of the
earphones (L) will flash red and blue within 5 seconds, and
the other earphone (R) will not flash.
Step3: Turn on the cellphone Bluetooth, search for
“W wireless earphone”,clicking it, the left channel will prompt
the “ connected” ( two earbuds will flash blue light slowly)
Slow flashing blue lights
Slow flashing blue lights
“W wirsless earphones”
W wireless earphone
Step 1: delete bluetooth history record (“W wireless
earphone”) on yourphone.
Step 3: put earbuds in charging case.
Step 2: turn off bluetooth on your phone.
Flash red
Step 5: Hold and long press the picked one for 4s, then
flashing red and blue.
Step 6: turn on bluetooth on your phone and search
“W wireless earphone”.
Flash blue and red in 4s
“W wirsless earphones”
Attention Gentle hint
When the earbud is fully charged, the indicator light will
change from red to off, then the earphone will enter into the
pairing mode with your mobile phone. If it is failure to seach
your bluetooth device, the earbuds will turn off after 3 minutes.
When charging the earbuds, you need to cover the lid of the
charging case
When using dual earphones, the effective distance between
the left earphone and the right earphone is within 10 meters;
when the two earphones are separated by this distance, the
playback of earphone will be intermittent.
When the two earbuds are connected, only one has sound or
no soundThe solution is as follows
1.Strong recommend full charge at first time.
2.Stand-by Time: About 100 hours
3.Call Time: About 240 mins
4 Play Time: About 240 mins
5 Earbuds Charging Time: About 60 mins
3.Hold and long press the right and left earphone for 2 seconds
at the same time, the indicator of left one will flash red and blue,
the right is no light flash. Then connect bluetooth on your mobile
phone to binuaural TWS palyback mode.
2.Then put one into the your ear, press and hold the multifuntion
key for 12--13 seconds,you will hear the voice prompts “deng deng”;
then release. ( the other do the same operating mode)
Turn them on until flashing red
light, and then release
TWS mode multifunction key
Press multifunction key
( left or right) : play/pause
Double-click the left
earphone: volume +
Three-click the left
earphone: volume –
Double-click the right
earphone: volume –
Three-click the right
earphone: volume +
1. Turn off the earbuds;
2.The earphone underwater more than 5 minutes, you need to
dry the water when you use it again. Otherwise, While the
earphone sound is loud, the earphone sound is small or the call
sound is small.
3.If the earphone is entered some water, please remember to
put it in a ventilated place to dry it and then use it again. Do not
charge with water directly.
4.Waterproof performance is only applicable to fresh water,
tap water, sweat, swimming pool water and salt water. Under
certain circumstances in the above five types of environment,
the waterproof performance may not be applicable. Waterproof
performance is not applicable in other liquid environments
except the above five types.
5.The earphone is IPX7 waterproof, the charging compartment
is not waterproof, please do not seep into the interior when using.
Step 4: take out the one you want to use, then press and hold
to turn it off.(Because the earbuds will automatically turn on after
taking out the charging case)
Flashing blue and red
No light flashing
  • Page 1 1

SZSAGO W5S-GREY User guide

Brand
SZSAGO
Model
W5S-GREY
Type
User guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents