INSTALL/REMOVAL INSTRUCTIONS: KEYLESS ENTRY REMOTE
99132
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualied auto technician
before attempting to perform any work you are not qualied to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Trac Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specic service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualied technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
1
©2019 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
REMOVAL/INSTALL OF KEYLESS ENTRY REMOTE (99132)
Subaru 2007–97
To program a new transmitter, it is necessary to program the transmitter’s 8 digit
code into the vehicle. A label with an eight-digit number is located on the outside of
our remote. (Original remotes will have this code on the circuit board).
STEP 1: Locate 8-digit remote code of new remote to be programmed. Code is located on
the outside of our remote. (Original remotes will have code on circuit board.)
STEP 2: Unlock vehicle using existing remote.
STEP 3: Open and close door ONE time. The next step must be completed
within 45 seconds.
STEP 4: Within 45 seconds, insert key into ignition and without starting vehicle turn
from LOCK to ON 11 times ending in the ON position. (Instrument panel will light up
in the ON position.)
STEP 5: Open and close driver door ONE time. A constant faint chime will sound
indicating your vehicle is in programming mode and is ready to accept a new remote.
The next step must be completed within 45 seconds.
STEP 6: Within 45 second of your vehicle entering programming mode, begin registering
your 8-digit code of the remote to be programmed:
STEP 7: Press power door lock button to LOCK the same number of times as the rst digit
of your remote code found in step 1.
STEP 8: Within 5 seconds press the power door UNLOCK button.
STEP 9: Repeat steps 7 and 8 for all remaining digits of remote code.
STEP 10: When you are nished with step 9, press the power door UNLOCK button on the
car door once.
STEP 11: Repeat steps 7 through 9 a second time to conrm the 8-digit remote code.
STEP 12: When the 8-digit code has been entered a second time a faint chime will sound
for 30 seconds.
STEP 13: Remove key, open/close door and test remote.
