PAGE 1
306540
DPF-MRK-003 REV A 9/9/16
MESH FRONT CALIPER COVERS, ‘08-UP DYNA & ‘08-’14 SOFTAILS, CHROME
6540
866 277 9598 | INFO@KURYAKYN.COM
454 COUNTY ROAD VV SOMERSET, WI 54025
KURYAKYN.COM
INSTALLATION INSTRUCTIONS
THANK YOU FOR CHOOSING KURYAKYN!
Protect yourself and others from possible injury and property damage or loss. Pay close attention to all instructions, warnings, cautions, and notices regarding the installation, use, and care of this product.
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN CAN RESULT IN POTENTIAL DEATH OR SERIOUS INJURY.
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN CAN RESULT IN MINOR OR MODERATE POTENTIAL INJURY.
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN MAY NEGATIVELY AFFECT PRODUCT PERFORMANCE AND FUNCTIONALITY OR
DAMAGE THE PRODUCT ITSELF OR THE PRODUCT TO WHICH IT IS BEING ATTACHED.
ENSURE THAT THE FOLLOWING PARTS HAVE BEEN INCLUDED IN THE KIT:
1 Front Caliper Cover
YOU WILL ALSO NEED:
12 Point Socket and Racket Set
THESE INSTALLATION INSTRUCTIONS CONTAIN IMPORTANT INFORMATION. ENSURE THE END USER RECEIVES THIS COPY AND IS AWARE
OF ITS IMPORTANCE FOR FUTURE USE.
STEP 1
Read and understand all steps in the instructions before starting the
installation. Park the motorcycle on a hard, level surface and turn off
the ignition. Let motorcycle cool.
A FACTORY SERVICE MANUAL MAY BE HELPFUL IN PERFORMING THIS
INSTALLATION. DO NOT ATTEMPT TO PERFORM THIS INSTALLATION IF
YOU ARE NOT CONFIDENT IN YOUR ABILITY TO COMPLETE ALL OF THE
STEPS IN THE PROCEDURE; CONSULT A TRAINED TECHNICIAN.
STEP 2
Refer to PIC 1. Remove the top 12 point bolt that attaches the caliper
to the left side fork leg.
STEP 3
Refer to PIC 2 and 3. Place the bolt through the top hole in the Caliper
cover and loosely attach it back through the fork leg to the caliper.
Note: If bike is equipped with ABS, the caliper cover goes over the ABS
module and wiring.
STEP 4
Refer to PIC 4 and 5. Remove the bottom 12 point bolt, pivot the
Caliper cover on the top bolt towards the fork leg and install the bottom
bolt through the fork leg to the caliper. Tighten the bolts to the factory
torque specs.
PIC 1
PIC 2
PIC 4
PIC 3
PIC 5
PAGE 2
306540
DPF-MRK-003 REV A 9/9/16
MESH FRONT CALIPER COVERS, ‘08-UP DYNA & ‘08-’14 SOFTAILS, CHROME
6540
866 277 9598 | INFO@KURYAKYN.COM
454 COUNTY ROAD VV SOMERSET, WI 54025
KURYAKYN.COM
INSTALLATION INSTRUCTIONS
-CONTINUED-
STEP 5
Check the bottom of the caliper cover to make sure you have clearance
from the brake rotor and tire valve stem.
IT IS THE INSTALLER’S RESPONSIBILITY TO ENSURE THAT ALL OF THE
FASTENERS (INCLUDING PRE-ASSEMBLED) ARE TIGHTENED BEFORE
OPERATION OF THE MOTORCYCLE. KURYAKYN WILL NOT PROVIDE
WARRANTY COVERAGE ON PRODUCTS OR COMPONENTS LOST DUE
TO IMPROPER INSTALLATION OR LACK OF MAINTENANCE. PERIODIC
INSPECTION AND MAINTENANCE ARE REQUIRED ON ALL FASTENERS.
LIMITED WARRANTY
Kuryakyn warrants that any Kuryakyn products sold hereunder, shall be free of defects in materials & workmanship for a period of one (1) year from the date of
purchase by the consumer excepting the following provisions:
1. Kuryakyn shall have no obligation in the event the customer is unable to provide a receipt showing the date the customer purchased the product(s).
2. The product must be properly installed, maintained & operated under normal conditions.
3. Kuryakyn shall not be liable for any consequential & incidental damages, including labor & paint, resulting from failure of a Kuryakyn product, failure to deliver,
delay in delivery, delivery in nonconforming condition, or for any breach of contract or duty between Kuryakyn & a customer.
4. Kuryakyn products are often intended for use in specific applications. Kuryakyn makes no warranty if a Kuryakyn product is used in applications other than
intended.
5. Kuryakyn electrical products are warranted for one (1) year from the date of purchase by the consumer. L.E.D.’s contained in components of Kuryakyn products will
be warranted for defects in materials & workmanship for 3 years from the date of purchase whereas all other components shall be warranted for one (1) year.
6. All warranty claims must be directed to the place of purchase. Merchandise sold through internet auction sites or any other unauthorized reseller shall not carry a
Kuryakyn warranty. If unsure, please contact the place of purchase to verify they are an authorized Kuryakyn reseller.
RETURN POLICY
Merchandise determined to be defective may be returned up to one year from the date of purchase. Returns must be processed through original seller. Returned
merchandise for any other reason other than warranty claims must be in like new condition & subject to a 20% restocking fee. All returns are subject to inspection
for determination of full or partial credit. Any returned part that shows evidence of being used or installed contrary to manufacturer’s instructions, &/or subjected to
improper handling, packaging or return shipping by the customer, will not be eligible for exchange, refund or warranty consideration. All returned electrical items will be
inspected & tested. If electrical item is deemed functional, no credit will be issued & item will be returned. All sales are final on discontinued or closeout merchandise.
©2015 KURYAKYN HOLDINGS, LLC ALL RIGHTS RESERVED
KURYAKYN, KURYAKYN K logo and the marks appearing on this instruction sheet are registered and common law trademarks of Kuryakyn Holdings except noted third-party trademarks. A full listing of trademarks and
trademark registrations owned by Kuryakyn Holdings can be found at www.kuryakyn.com/legal-notice.
Emissions Notice: The California Air Resources Board (CARB) does not permit the use of aftermarket emission-related parts(s) that alter the performance of OEM emission-related devices unless CARB has issued an
Executive Order, other than on racing vehicles on closed courses. Check your local laws and manufacturer’s information.
Listed Manufacturers and product model names are for reference only. All product and company names are trademarks or registered trademarks of their respective holders. Use of them does not imply any affiliation with or
endorsement by them. All specifications are subject to change without notice.
For additional information on third-party product and company names, please consult our Web page at www.kuryakyn.com/legal-notice
FINAL
/