1. Always use the locking mechanism which locks the lifting rollers in position before operate the loaded hydraulic wheel dolly.

2. Potential slip/fall hazard. Never stand or ride on the hydraulic wheel dolly when working with the Machine.

3. Never use the hydraulic wheel dolly unit for wheels of larger diameter. Wider or heavier than those stipulated in the technical specication.

4. The Support Arm (N°4) and Clamp Support Arm (N°1) are only to be used to balance the wheel, NOT to carry a load!

5. The hydraulic wheel dolly unit must only be used on horizontal workshop oors. Swept dean of any debris, the use of the unit on a sloping surface is

6. Never drive the unit over edges, rough surfaces, or corners etc. When there is a load on it as the whole unit can overturn.

7. It is of the greatest importance for safety that the unit is secured by the locking Pin (N°9) on the nearest hole before operating the unit. If this lock is not

Type D = 2 years. See the general conditions in the FACOM price list. Subject to compliance with all of the above instructions.

Position the vehicle on a suitable horizontal oor, applying the break. Jack up the axle of the wheel to be changed, with a suitable trolley jack, so that it is clear

of the oor. Secure with axle stands.

I. Using the hydraulic wheel dolly. Unlock the pin (N°9), then press the control pedal (N°7) to A position Pump apart the hydraulic wheel dolly with the pump

lever (N°6) to make the Roller Table (N°5) in to right position.

2. Adjust the wheel support Arm (N°4) so that the clamp support arm (NO.1) is positioned over the wheel to be handled.

3. Push the hydraulic wheel dolly unit under the wheel so that the roller tab les are positioned either side of the wheel and that the wheel sits up against the

must be secured in the lifting position with the lock Pin (N°9).

while it is being handled.

7. With the wheel nuts removed, the wheel can now be safely carried away on the hydraulic wheel dolly.

8. Put Pump Level (N°6) into Socket (N°11) used same as a handle as (N°12), thus the whole machine can be pushed to move.

When the wheel is located on the wheel studs and secured with wheel nuts or the wheel has been moved to a place for storage, the wheel can be released.

1. Lift and release the locking Pin (N°9).

2. Press the Control pedal (N°7) to the A position. Operate the pump lever (N°6).

3. Loose n Clamp Support Arm (N°1) by releasing Lock arm (N°2 and N°3).

of their training and experience are familiar with the hydraulic systems used in these devices.

1. Clean and lubricate the axes of the moving parts of the hydraulic wheel dolly at regular intervals. The hydraulic wheel dolly should be kept

clean and protected from aggressive conditions at all times.

2. Only original spare parts should be used.

3. Withdraw the hydraulic wheel dolly from service if it is suspected that it has been subjected to abnormal loads or has suffered any type of knock

until the problem has been resolved.

4. If the oil level needs to be checked or relled, dismantle the hydraulic unit and with the piston fully retracted, remove the ller plug and drain its

contents into a container. With the hydraulic in a horizontal position, proceed to introduce the necessary volume for each model as indicated in these

instructions. Avoid the entrance of any dirt with the new oil.

remaining parts in accordance with local regulations.

9. Both the repair kit, which exclusively contains the retainers and joints and the spare part sets must be ordered using the reference

assigned in the table.