Kohler K-201-NA Installation guide

K-201-NA
Kohler
Brand
Kohler
Model
K-201-NA
Category
Sanitary ware
Type
Installation guide

Kohler K-201-NA is a water filtration replacement cartridge designed to reduce sediment, rust, chlorine, and cysts from your drinking water. It has a capacity of 1,500 gallons and should be replaced every 3-6 months. The K-201-NA is easy to install and can be used with Kohler faucets and other brands.

Kohler K-201-NA is a water filtration replacement cartridge designed to reduce sediment, rust, chlorine, and cysts from your drinking water. It has a capacity of 1,500 gallons and should be replaced every 3-6 months. The K-201-NA is easy to install and can be used with Kohler faucets and other brands.

Installation Guide
Water Filtration Replacement Cartridge
M product numbers are for Mexico (i.e. K-12345M)
Los números de productos seguidos de
M corresponden a México (Ej.
K-12345M)
Français, page“ Français-1”
Español, página“ Español-1”
K-201, K-202, K-203
1014875-2-F
INSTR 2026 0404
Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems please don’t
hesitate to contact us. Our phone numbers and website are listed on
the back cover. Thanks again for choosing Kohler Company.
Before You Begin
Observe all local plumbing and building codes.
Shut off the main water supply.
Inspect the tubing for any sign of damage. Replace if necessary.
If possible, install this faucet before installing the sink.
If installing to other than a Kohler Side Spout faucet, you will
need to purchase an adapter to connect the outlet of the filter to
the faucet inlet.
This system and installation must comply with state and local
laws and regulations.
Only install the filtration system to a cold water supply. Do not
use with hot water systems.
Filter cartridges should be replaced every 3-6 months, when
capacity has been exceeded, or when a noticeable decrease in flow
is observed.
If needed, clean the exterior of the unit with mild soap and water.
Do not use chemical cleaners. Do not connect to a dishwasher.
Do not install the filtration system to a water line whose pressure
exceeds 125 psi (862 kPa).
Make sure the unit is not installed with hoses under tension. Do
not overtighten connections.
Keep the filter and plastic cartridges away from heat or flame.
Do not install the unit where the temperature may drop below
freezing.
This unit is designed to be installed under a sink. Make sure that
the bottom of the filter cartridge is at least 2″ (5.1 cm) from the
floor of the cabinet.
Kohler Co. reserves the right to make revisions in the design of
faucets without notice, as specified in the Price Book.
1014875-2-F 2 Kohler Co.
INSTR 2026 0404
1. Remove the Existing Cartridge
NOTE: The filter assembly may be removed from the cabinet wall to
help facilitate cartridge replacement.
Firmly grasp the filter cartridge and slowly turn it 90° clockwise
until the groove in the cartridge lines up with the ″OFF″ on the
filter head. The system will automatically cut off the water supply
when the cartridge is removed.
Pull the cartridge down to remove it. A small amount of water
may be discharged during removal.
Discard the old cartridge.
Cartridge
Groove
Cap
Filter Head
Filter
Cartridge
Write the date on
the cartridge label.
Kohler Co. 3 1014875-2-F
INSTR 2026 0404
2. Install the New Cartridge
Write the installation date on the new filter cartridge label.
Remove and discard the cap.
Inspect the cartridge for any damage.
Make sure that both O-rings are present and positioned correctly
in the grooves.
Moisten the O-rings with water. Do not use petroleum products
to lubricate the O-rings.
Align the groove in the top of the cartridge with the ″OFF″ on the
filter head.
Insert the top of the cartridge into the filter head.
O-Rings
Cap
Cartridge
Filter
Groove
Write the date on
the cartridge label.
1014875-2-F 4 Kohler Co.
INSTR 2026 0404
Install the New Cartridge (cont.)
Turn the cartridge counterclockwise 90° until it stops.
Run the faucet for at least 2 minutes for models K-201 and K-202
or 10 minutes for model K-203 to remove any air in the system.
Any air left in the system may temporarily cause the water to be
cloudy.
Check for leaks.
Kohler Co. 5 1014875-2-F
INSTR 2026 0404
Cartridge Replacement Information
Do not use with water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system. Systems certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
Filter cartridges should be replaced every 3-6 months, when capacity has been exceeded, or
when a noticeable decrease in flow is observed, whichever comes first.
Service Parts and Replacement Cartridges are available from your local distributor
or directly from Kohler Co.:
Kohler Co., 444 Highland Drive, Kohler, Wisconsin, 53044
EPA Establishment No. 070595-CT-001
K-202 Premium Filter Cartridge offers mechanical reduction of particulates, sediment/rust,
turbidity and cysts, and chemical reduction of chlorine taste and odor, and lead.
Pressure: 30-125 psi (206-862 kPa) Flow Rate: 0.6 gpm (2.27 Lpm)
Temperature: 40˚-100˚ F (4.4˚-38˚ C) Capacity: 1,500 gallons (5,678 L)
K-203 VOC Filter Cartridge offers mechanical reduction of particulates, sediment/rust, and
chemical reduction of chlorine taste and odor, volatile organic chemicals and MTBE
Pressure: 30-125 psi (206-862 kPa) Flow Rate: 0.6 gpm (2.27 Lpm)
Temperature: 40˚-100˚ F (4.4˚-38˚ C) Capacity: 400 gallons (1,514 L)
K-201 Hi Flow Filter Cartridge offers mechanical reduction of particulates, sediment/rust and
cysts, and chemical reduction of chlorine taste and odor.
Pressure: 30-125 psi (206-862 kPa) Flow Rate: 1.5 gpm (5.68 Lpm)
Temperature: 40˚-100˚ F (4.4˚-38˚ C) Capacity: 1,500 gallons (5,678 L)
Tested and Certified by NSF International against NSF/ANSI Standard 42
for the reduction of Nominal Particulate (Class I), Chlorine Taste and
Odor, and against NSF/ANSI Standard 53 for the reduction of Cysts and
Turbidity in Model K-200/K-201, K-6665-F/K-201 and K-6666-F/K-201.
Tested and Certified by NSF International against NSF/ANSI Standard 42
for the reduction of Nominal Particulate (Class I), Chlorine Taste and
Odor, and against NSF/ANSI Standard 53 for the reduction of Cysts,
Turbidity and Lead in Model K-200/K-202, K-6665-F/K-202 and K-
6666-F/K-202.
Tested and Certified by WQA International against NSF/ANSI Standard 42
for the reduction of Nominal Particulate (Class I), Chlorine Taste and
Odor, and against NSF/ANSI Standard 53 for the reduction of VOC, and
MTBE in Model K-200/K-203, K-6665-F/K-203 and K-6666-F/K-203.
ASSOCIATION
®
Replacement
Element
Replacement
Element
Replacement
Element
1014875-2-F 6 Kohler Co.
INSTR 2026 0404
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
1014875-2-F
INSTR 2026 0404
Page is loading ...
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20

Kohler K-201-NA Installation guide

K-201-NA
Kohler
Brand
Kohler
Model
K-201-NA
Category
Sanitary ware
Type
Installation guide

Kohler K-201-NA is a water filtration replacement cartridge designed to reduce sediment, rust, chlorine, and cysts from your drinking water. It has a capacity of 1,500 gallons and should be replaced every 3-6 months. The K-201-NA is easy to install and can be used with Kohler faucets and other brands.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents