Princess 212024 Datasheet

Page is loading ...

Ml

Nederlands 1

English 5

Français 9

Deutsch 13

Español 17

Italiano 21

Svenska 25

Dansk 29

Norsk 33

Suomi 37

Português 41

ǼȜȜȘȞȚțȐ 45

49

Page is loading ...

5

Article 212024 Princess Arctic Blender

General

You can use this attractive Princess Arctic

Blender to finely chop vegetables and fruit,

and to prepare delicious shakes and

juices.

The blender is equipped with a powerful

motor that can be set to one of two

continuous speeds or a pulse mode. The

sharp stainless-steel knives enable you to

finely chop or puree both small and large

pieces of fruit and vegetables with the

greatest of ease.

This useful appliance also has a closable

lid; the filling opening in the lid can be used

to add ingredients during blending without

spillage.

The rubber feet under the blender prevent

it from moving whilst in use.

Operation and

Controls

See Figure 1.

The appliance is equipped with the

following features:

1Lid insert

2Lid

3 Calibrated jug

4 Knife with sealing

5Ring

6 Power cord and plug

7 Selector/switch

8 Housing

Before first use

1 Take the appliance out of the

packaging.

2 Make sure that the mains voltage is the

same as indicated on the type plate on

the appliance.

3 Clean the appliance. See ‘Maintenance

and cleaning’.

Use

Fitting the parts

1 Fit the jug to the housing. The three

lugs on the housing must fit precisely

into the slots in the base of the jug.

2 Place the lid on the jug.

3 Fit the lid insert in the lid, and lock it by

turning it clockwise.

Selector/switch

The selector/switch has 4 positions:

Blending products

1 Cut the fruit and/or vegetables into

pieces that fit in the jug. Do not cut into

pieces that are too large, since they will

need to be small enough to fall to the

base of the jug.

2 Remove the lid and put the pieces in

the jug.

3 Fit the lid with the lid insert onto the jug

to prevent splashing.

4 Switch on the blender by rotating the

selector/switch to position I or II, or to

the pulse position (P).

The blender works very fast. In a few

seconds the product will be chopped.

The smoothness of the blend increases

with longer blending times.

5 If necessary, top up the contents by

removing the lid insert: rotate the lid

insert anti-clockwise and remove it from

the lid. If the pieces are too large for the

filling opening then switch off the

blender, remove the lid, and add the

Pos. Function

0Off

I Continue low speed

II Continue high speed

P Pulse mode

6

Article 212024 Princess Arctic Blender

product. Put the lid back on the jug

before switching the blender on again.

6 Switch off the blender once you have

processed the required quantity of fruit

and/or vegetables.

7 Remove the plug from the wall socket.

• Never allow the power cord to hang

over the edge of the draining board,

worktop or table.

• Never use the appliance outdoors.

• Use an earthed wall socket.

• Never use the appliance in a humid

room.

• Always remove the plug from the wall

socket after use.

• Make sure your hands are dry when

you touch the appliance, the power

cord or the plug.

• Switch off the appliance and remove

the plug from the wall socket in the

event of a malfunction during use,

before cleaning the appliance, before

fitting or removing an accessory and

before storing the appliance after use.

• Take care when touching the

appliance and its parts. Allow the

appliance to cool down first. The

appliance and its parts will become

hot whilst the appliance is in use. The

appliance’s housing will also become

hot, since the housing is an excellent

conductor of heat.

• Never leave the appliance unattended

when in use.

• Always close the lid before switching

on the appliance.

• Hot liquids in the blender may result in

the lid flying off due to the steam and

pressure caused by the hot liquid.

Prevent this from happening by

holding the lid down with a cloth

whilst the blender is in use.

• The blender works very quickly. The

ingredients are ground within just a

few seconds. The longer the blender

is switched on, the finer the products

will be ground.

• To overcome overheating, do not

switch on the blender longer as three

minutes continuously.

• Never let the appliance operate with

an emty jug.

Maintenance

and Cleaning

1 Remove the plug from the wall socket.

2 Clean the housing of the appliance with

a soft, damp cloth.

3 Turn the ring loose from the bottom of

the jug and remove the knife and the

rubber sealing ring.

4 Clean the jug, the knife, the sealing

ring, the lid and the lid insert in warm

soapy water.

5 Rinse all parts with fresh water.

6 Dry all parts.

7 After cleaning position the knife with the

rubber sealing to the bottom side of the

jug and fixate it by turning the ring on

the jug.

8 Fit all the parts to the blender (see

‘Fitting the parts’), close the lid, and

store the appliance.

• This blender uses sharp knives, which

are located in the bottom of the

container. Therefore, be very careful

when emptying and cleaning the

blender. Avoid cutting yourself on the

knives.

• Make sure no moisture comes into

contact with the appliance’s electrical

parts.

• Never immerse the appliance, the

power cord or the plug in water or

other liquids.

7

Article 212024 Princess Arctic Blender

• Never use aggressive or abrasive

cleaning products or sharp objects

(such as a knife or a hard brush) to

clean the appliance.

• Only the loose parts (like the jug, the

lid and the lid insert) may be cleaned

in a dishwasher. The appliance itself

may not be cleaned in the dishwasher.

Storage

1 Remove the plug from the wall socket.

2 Clean the appliance. See ‘Maintenance

and cleaning’.

3 Store the appliance in a frost free and

dry location.

• Store the appliance out of reach of

children.

Safety

• Read and follow these instructions

carefully. Keep this manual for future

reference.

• Use this appliance only in accordance

with these instructions.

• This appliance is intended solely for

domestic use.

• The use of this appliance by children

or persons with a physical, sensory,

mental or motor disability or who lack

the necessary knowledge and

experience may cause a hazard.

Persons responsible for the safety of

such people must give explicit

instructions or supervise the use of

the appliance.

• Keep the appliance out of the reach of

children, and of persons who may not

be able to operate it safely.

• Have the appliance repaired only by a

qualified electrician. Never try to

repair the appliance yourself.

• Only use accessories recommended

by the supplier. The use of other

accessories may result in damage to

the appliance, thereby creating

hazards for the user.

• The appliance is not intended to be

operated by means of an external

timer or separate remote control

system.

• Always remove the plug from the wall

socket when the appliance is not in

use.

• Always remove the plug from the wall

socket by pulling on the plug not the

power cord.

• Never pull the power cord to move the

appliance.

• Do not use the appliance if the

appliance or the power cord is

damaged. Have a damaged power

cord replaced by a qualified

electrician.

• Make sure that the appliance, the

power cord and the plug do not come

into contact with sources of heat such

as a hot hob or naked flame.

• Make sure that the appliance, the

power cord and plug do not come into

contact with water, other fluids or

chemicals.

• Do not pick up the appliance if it falls

into water. Immediately remove the

plug from the wall socket. Do not use

the appliance anymore.

8

Article 212024 Princess Arctic Blender

U.K. Wiring

Instructions Class 1

The wires in the mains lead are

coloured in accordance with the

following code:

As the colours of the wires in the mains

lead of this appliance may not

correspond with the colour markings

identifying the terminals on your plug,

proceed as follows:

• The BLUE wire must be connected to

the terminal marked with the letter N

or coloured black.

• The BROWN wire must be connected

to the terminal marked with the letter L

or coloured red.

• The GREEN/YELLOW wire must be

connected to the terminal marked with

the letter E (or earth symbol) or

coloured GREEN or GREEN/YELLOW.

If a 13A plug (BS1363) is used a 3A fuse

(BS1362) should be fitted. If any other

type of plug is used, a 13A fuse must be

fitted either in the plug or adapter, or on

the distribution board.

WARNING: THIS APPLIANCE MUST BE

EARTHED

The Environment

Dispose of packaging material, such as

plastic and boxes, in the appropriate waste

containers.

If you wish to dispose of the appliance

whilst it still works properly or can be easily

repaired, then ensure that the appliance is

recycled.

When the appliance reaches the end of its

useful life, it should be disposed of in a

responsible manner, thereby ensuring the

reuse of the appliance or its parts. Do not

dispose of the appliance with unsorted

refuse; hand it in at the store, or take it to a

recognized collection point. Contact your

municipality for information about the

reception and collection systems in your

area.

CE Conformity

Applicable European guideline:

2002/95/EC

2002/96/EC

•BLUE NEUTRAL

•BROWN LIVE

• GREEN/ YELLOW EARTH

Page is loading ...

Princess 212024 Datasheet

Princess 212024 Datasheet

in other languages

Related papers

Other documents