A
sh/Stash Assembly
instruction sheet
Medium Ash/Stash Parts
1 - Shell 1 - Back 1 - Liner
Medium Ash/Stash Masonry Installation
1 Position back in the desired location
and mark the mounting surface through the
holes.
2 Drill holes in the mounting surface to
the depth required for anchors.
3 Install anchors.
4 Place back over the anchors and
fasten securely.
Wood Installation
1. Same as above
2. Install screws Note: Anchors and screws are
not supplied. Liner may be replaced using a
standard 2 lb. coffee can. Periodic replacement
may prevent discoloration of the unit.
Large Ash/Stash Parts
1 - Shell 1 - Liner 1 - Set of Keys
Large Ash/Stash Masonry Installation
1 Position shell in the desired location
and mark the mounting surface through the
holes.
2 Drill holes in the mounting surface
to the depth required for anchors.
3 Install anchors.
4 Place shell over the anchors and
fasten securely.
Wood Installation
1 Same as above
2 Install screws
Note: Anchors and screws are not supplied.
211 N. Lindbergh Blvd. • St. Louis, MO 63131-7809
800-231-1327 • www.landscapebrands.co
m
/
