Swiss Madison SM-GR90BSM-GR90B, SM-GR90GSM-GR90G, SM-GR90SISM-GR90SI Installation guide

  • Hello! I've reviewed the installation instructions for the Glass Rinser. This document provides a step-by-step guide for installing the rinser, including pre-installation advice, recommended tools, and parts list. I'm ready to answer any questions you may have about the installation process or the included components.
  • What should I do before starting the installation?
    What tools are recommended for the installation?
    What are the included parts?
1. Turn Off Water Supply
· Turn off water supply at angle stops.
2. Disassemble
· Remove rubber washer and support washer from the
mounting shank.
3. Install Rinser
· Place mounting shank through sink hole.
· From below, screw on the rubber washer and support
washer to the mounting shank to secure.
4. Connect Water Supply
· Attach water supply hose to the base of the rinser.
· Connect other end of water supply hose to angle stops
using the T-pipe.
· Turn on and check for leaks.
INSTALLATION INSTRUCTIONS
Glass Rinser
swissmadison.com | 1-434-MADISON | [email protected]
Prior to Installation:
· Inspect product to ensure no damages have
occurred while in shipping.
· The step-by-step guidelines in the installation instructions
are a general reference. Should there be any
discrepancies, Swiss Madison cannot be held liable. It is
recommended to install all Swiss Madison products by
hiring a licensed professional.
· Read installation and maintenance instructions thoroughly
before installing. Be sure to use proper tools and always
wear proper personal safety accessories for your protection.
· Check installation area and make sure nothing is within 2” of
the installation hole as it may interfere with the product.
Recommended Tools:
· Wrench
· Silicone
· Bucket
· Flashlight
Included Parts:
· Glass Rinser
· T-Pipe
· Washers
· Supply Hose
well made for e v e r
/