1181 South Rogers Circle, Suite 18
Boca Raton, Florida 33487
e-mail [email protected]
www.jti-innovation.com
MATRIX
®ELITE SUBWOOFERS
09/02
12
3
5
7
9
8
6
4
Congratulations on your purchase of an Oz Audio®Matrix®Elite Series subwoofer.
The Matrix®Elite subwoofer represents Oz Audio’s®obsession to create the ultimate in
subwoofer technology. Every part of this subwoofer was designed and scrutinized to
ensure maximum SPL. We hope you will enjoy your Matrix®Elite subwoofer for many
years to come.
Features of the MATRIX®ELITE Subwoofer include:
• U-Turn Hyper-Surround™for maximum linear excursion
• Triple layer glass fiber cone with nomex center
• Powder coated, die-cast aluminum basket
• UnderLap™cone attachment
• Flat progressive roll conex spider with inter-woven wire leads
• Dual wound, two inch dual voice coils on a glass fiber former
• Cross-Vent™intercooling basket design
• Triple stacked 150 oz. magnet structure
• Custom engraved chrome back-plate with vented radius
• Extended coil windings for increased Xmax
• Double sided engraved rubber gasket
• Protective rubber magnet sleeve
• Specially designed vacuum formed dust cap
• Nickel plated push terminals
3
1
2
4
5
6
7
8
9
1.
Enclosure Recommendations
F348 Hz 50 Hz 47 Hz 47 Hz 40 Hz 39 Hz
NOTE: Add driver, port, and brace displacement to the recommended enclosure
volume to find the gross enclosure volume.
MATRIX¨ELITE Specifications
MODEL OZ OZ OZ OZ OZ OZ
Me10.2 Me10.4 Me12.2 Me12.4 Me15.2 Me15.4
Fs (Hz) 35 36 33 34 26 27
Qts .562 .553 .66 .66 .598 .835
Qes .599 .589 .711 .711 .659 .958
Qms 9 9 9.177 9.177 6.5 6.5
Vas (Liters) 22.59 23.09 49.93 50.02 163 163
Re () 1.6 3.3 1.6 3.3 1.6 3.3
Xmax (mm) 25 25 25 25 25 25
Sens (db
1W/1M)
Sens (dB
2.83V/1M)
Rms/Peak
(Watts)
Mounting
Depth (inches)
Mounting
Diameter
The Matrix¨Elite subwoofers are some of the most versatile speakers available for the
most discriminating listener. They are designed to perform well in sealed, vented, or
bandpass enclosures.
Displacement
(cu. ft.) .112 .112 .153 .153 .231 .231
9.125 9.125 11.125 11.125 14.125 14.125
6.5 6.5 7.125 7.125 8.0625 8.0625
500/1000 500/1000 500/1000 500/1000 700/1400 700/1400
94.13 91.52 96.06 93.31 98.43 94.34
84.13 84.66 86.06 86.46 88.43 87.35
SEALED OZ OZ OZ OZ OZ OZ
Me10.2 Me10.4 Me12.2 Me12.4 Me15.2 Me15.4
Box Volume .8ft. 3.8ft. 31ft.31ft.31.75 ft. 31.75 ft. 3
VENTED OZ OZ OZ OZ OZ OZ
Me10.2 Me10.4 Me12.2 Me12.4 Me15.2 Me15.4
Box Volume 1.25 ft.31.25 ft.31.5 ft.31.5 ft.32.5 ft.32.5 ft.3
F334 Hz 34 Hz 34 Hz 34 Hz 36 Hz 36 Hz
4 " / 11" 4" / 11" 4"/10.5" 4" / 10.5" (2) 4" / 13.75" (2) 4" / 13.75"
12.56 in.212.56 in.212.56 in.212.56 in.225 in.225 in.2
/ 11" / 11" / 11" / 10.5" / 12.75" / 12.75"
Round Port
Diameter / Length
Square Port
Area / Length
BANDPASS OZ OZ OZ OZ OZ OZ
Me10.2 Me10.4 Me12.2 Me12.4 Me15.2 Me15.4
Rear Box Vol. 1 ft.30.9 ft.31 ft.31 ft.32.75 ft.32.75 ft.3
Front Box Vol. 0.9 ft.30.6 ft.31.5 ft.31.5 ft.32.75 ft.32.75 ft.3
F3L40 Hz 40 Hz 39 Hz 40 Hz 31 Hz 30 Hz
F3H72 Hz 72 Hz 79 Hz 82 Hz 84 Hz 84 Hz
4" / 10" 4" / 10" (2) 4" / 10.5" (2) 4" / 9.75" (3) 4" (3) 4"
/ 10.75" / 10.75"
12.56"in.212.56 in.225 in.225 in.239 in.239 in.2
/ 10" / 10" / 9.5" / 8.75" / 9" / 9"
Round Port
Diameter / Length
Square Port
Area / Length
Fb 54 54 55 57 50 50
2 3
Fb 43 Hz 43 Hz 40 Hz 40 Hz 39 Hz 39 Hz
Multiplying all three internal dimensions and then dividing the product by 1728 will pro-
duce the enclosure volume. (H" x W" x D") / 1728 = Enclosure Volume.
Enclosures should be constructed with 3/4 inch MDF to prevent flexing of the enclosure
walls. When assembling the enclosure all panels should be first glued, and then fastened
together with either a brad nailer or screws in pre-drilled holes. After the enclosure has
been assembled, all seams should be sealed with silicone caulk.
Enclosure recommendations are net internal volumes. Driver displacement, brace dis-
placement, and port displacement must be added to the volumes listed on the chart.
Typically, by adding 10 percent to a sealed enclosure volume, or 15 percent to a ported
enclosure volume, the extra displacement of the driver and port can be compensated for.
NOTE:
On vented enclosures, equalization is not recommended below the enclosure tuning
frequency (Fb). The end of port should be no closer than it’s own diameter to the wall
opposite the port opening.
05/03
Calculating Enclosure Volume
D
H
W
Impedance Formulas:
Series - Rt = R1 + R2 + R3 +…
Parallel - Rt = 1
(1/R1 + 1/R2 + 1/R3 +…)
NOTE:
Both voice coils must be connected to amplifier, regardless of wiring configuration
(series or parallel).
CAUTION
This high-performance subwoofer is capable of producing sound pressure levels that
can cause hearing impairment or permanent loss. Please avoid prolonged exposure to
sound pressure levels in excess of 100dB to prevent such damage. Oz Audio®assumes
no liability for bodily injury or property damage caused by the misuse of this product.
Due to ongoing product development, all specifications are subject to change without
notice. For detailed specifications on all Oz Audio®speakers, please visit our website
(www.ozaudio.com) or consult with your authorized Oz Audio retailer. To locate the near-
est Oz Audio®dealer, please call (561) 998-0211 between 9:00am and 6:00pm EST.
Monday thru Friday, or email us at [email protected], or write to JTI, 1181 South
Rogers Circle, Suite 18, Boca Raton, FL 33487.
Matrix
Elite Matrix
Elite
4 Ohms
Series Parallel Series Parallel
Matrix
Elite 8 Ohms1 Ohms Matrix
Elite
2 Ohms
Dual 2 Ohm Coils Dual 4 Ohm Coils
Wiring Diagrams
4 5
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
EXEL Tecnare E-6 Operating instructions
-
Stinger SEA10S4 Owner's manual
-
QSC E18SW User guide
-
Rockford Fosgate P2D212 User manual
-
Soundstream Tarantula TRX2.320 User manual
-
Memphis Power Reference Series User manual
-
Interfire Pro-X series Owner's manual
-
Rockford Fosgate P1-SVC Installation & Operation Manual
-
Phoenix Gold GX12D4 Owner's manual
-
Crossfire C7 Series Owner's manual
