Peavey Impulse Impulse 500 Reference guide

Impulse®500 Stacking Adapter

The Impulse®500 Stacking Adapter is designed for free-standing enclosures only.

Do not attempt to use this adapter with enclosures that are flown or wall mounted.

Do not attempt to stack more than two enclosures.

Follow instructions for installation as shown in the diagram below.

Use extreme care when picking the location or placement of any stackable enclosure. Stacked cabinets should

only be used on solid level surfaces and away from possible direct or accidental contact. Any cabinets used in a

stacked manner above floor level should be safety secured from above to prevent falling. Do not attempt to move,

transport, or change the placement of these enclosures while in a stacked configuration. Failure to follow the

advice above could result in personal injury.

1. Set Peavey number

00480230 or 00479150

stacking adapter on top of

bottom speaker as shown in

this view.

2. Set feet of speaker to be

stacked in holes of stacking

adapter.

SIDE VIEW ISOMETRIC VIEW

Features and specifications subject to change without notice.

Peavey Electronics Corporation • 711 A Street • Meridian • MS • 39301

(601) 483-5376 • FAX (601) 486-1278 • www.peavey.com

80304683

This manual is also suitable for

Download PDF