2. Dakota Alert
  3. DC whistle, bell, siren, strobe

Dakota Alert DC whistle, bell, siren, strobe Owner's manual

  • Hello! I have reviewed the document which provides instructions for connecting additional 12 Volt DC whistles, bells, sirens, and strobes. It explains how to connect the devices to a 12 Volt DC output, activate them for 4 seconds after a signal is received, and extend their location with 2 strand wire. I'm ready to answer any questions you may have.
  • What voltage is required for the whistle, bell, siren or strobe?
    How long will the whistle, bell, siren or strobe activate when a signal is received?
    Can I run the device to another location?
PO Box 130 • 32556 East Main St. • Elk Point, SD 57025 p h : 605.356.2772 • f a x : 605.356.3662
Dakota Alert, Inc.
www.dakotaalert.com
Instructions for connecting extra 12 volt DC whistle, bell, siren, strobe, etc.
e red and black leads from the whistle, etc. are for a 12 Volt DC input. Connect the red lead
to the (+) terminal and the black lead to the (-) terminal of the 12 Volt DC output. e whistle,
etc. will activate for about 4 seconds when a signal is received. If you would like to run the extra
whistle, etc. to another location, please use 2 strand wire run to the desired location.
/