Danfoss ICS 25-80 - Replacing the Teflon plate in the function module Installation guide

Hello! I am an AI chatbot trained to assist you with the Danfoss ICS 25-80 - Replacing the Teflon plate in the function module Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

Turn the module upside down and secure in a screw vice, hold-

ing the module on the two at sides (A).

Loosen the washer plate using a 13 mm (0.5 in.) spanner.

Unscrew the washer plate while holding on to the module (the

spring force will force the module to detach from the piston).

Remove the old/worn Teon seat from the washer plate. Mount

the new Teon seat on top of the regulating cone. Remember to

place the Teon seat with the at surface facing up.

Screw the washer plate back on to the module by hand.

Tighten the washer plate using a torque wrench.

ICS 25, 32 and 40 = 10Nm (7lb/ft)

ICS 50, 65 and 80 = 25Nm (18lb/ft)

NOTE!

It is important to tighten the washer plate with the correct torque, otherwise the washer plate may become loose or get

damaged!

Instructions

ICS 25-80

Replacing the Teon seat in the function module

027R9888

Kurt M.

Sand

Digitally signed by Kurt

M. Sand

DN: cn=Kurt M. Sand,

o=Automatic Controls,

ou=AC,

m, c=DK

Date: 2012.02.02

10:43:17 +01'00'

If the insert becomes detached from the piston,

follow the procedure below.

Place the spring in the module and insert the piston.

Squeeze the piston ring while pressing the piston into the

module.

Hold the piston in place while mounting the regulating cone,

Teon plate and washer plate. Tighten the washer plate using

the correct torque:

ICS 25, 32 and 40 = 10Nm (7lb/ft)

ICS 50, 65 and 80 = 25Nm (18lb/ft)

www.danfoss.com/ir