Cornelius CM1000 User manual

Category
Wall & ceiling mounts accessories
Type
User manual
1
91855 12/16/96
R
e
v
i
s
e
d
2
/
1
2
/
9
7
IMI CORNELIUS INC.
One Cornelius Place
Anoka. MN 55303-6234
Telephone (800) 238--3600
Facsimile (612) 422--3246
INSTALLATION INSTRUCTIONS
FOR INSTALLING A SCOTSMAN CM1000 SERIES ICE
MAKER ON REMCOR MODEL DB275 SERIES ICE
DISPENSER
Note: If dispenser has a flat stainless steel cover installed, it should be removed and discarded. Use
following instructions to assemble new cover and icemaker. Use page 2 for references.
1. Seal cover to dispenser as follows:
A. Unpack new cover assembly and run a bead of RTV on the cover bottom flanges to mate with dis-
penser hopper.
B. Set cover onto dispenser hopper.
C. Wipe excess RTV away immediately.
D. Cover must be sealed completely to dispenser hopper.
2. Seal icemaker to dispenser cover.
A. Apply a bead of RTV on the dispenser cover around the outline of the icemaker frame sides and rear.
B. Set icemaker onto cover.
C. Wipe excess RTV away immediately.
3. Secure icemaker to dispenser with mounting brackets provided as shown on page 2. Drill holes and install
sheet metal screws provided into icemaker cabinet. Drilling must not interfere with icemaker components.
4. Follow the manufacturers instructions to complete the installation of the icemaker.
2
91855
12/16/96
R
e
v
i
s
e
d
2
/
1
2
/
9
7
24
30
APPLY RTV ALONG BOTTOM EDGE OF ICE
RAMP AND FRONTHOPPER LIP. COMPLETE
LID MUST BE SEALED TO HOPPER.
ICEMAKER TO BE FLUSH
WITH BACK EDGE OF COVER
APPLY RTV AROUND INSIDE OF
ICEMAKER OUTLINE ON DISPENSER
COVER TO FORM A SEAL.
REMOVE SCREWS AND TURN BRACKETS
AROUND 180_. REPLACE SCREWS. USING
BRACKET AS TEMPLATE, DRILL (4) .136 DIA.
HOLES INTO ICEMAKER CABINET FOR
SCREWS PROVIDED. DRILLING IS NOT TO
INTERFERE WITH ICEMAKER COMPONENTS.
REMOVABLE FRONT LID FOR
MANUAL ICE FILLING.
  • Page 1 1
  • Page 2 2

Cornelius CM1000 User manual

Category
Wall & ceiling mounts accessories
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI