Inventum VST412BA Owner's manual

Type
Owner's manual
3
1. veiligheidsvoorschriften pagina 4
2. montage instructies pagina 7
3. het gebruik van de ventilator pagina 8
4. reiniging & onderhoud pagina 9
algemene service- en garantievoorwaarden pagina 27
1. safety instructions page 10
2. assembly instructions page 12
3. using the fan page 13
4. cleaning and maintenance page 14
general terms and conditions of service and warranty page 28
1. Sicherheitshinweise Seite 15
2. Anweisungen für die Montage Seite 18
3. Verwendung des Ventilators Seite 19
4. Reinigung & Wartung Seite 20
Allgemeine Service- und Garantiebedingungen Seite 29
1. consignes de sécurité page 21
2. instructions de montage page 24
3. utilisation du ventilateur page 25
4. nettoyage et entretien page 26
conditions générales de garantie et de service après-vente page 30
Nederlands
English
Deutsch
Français
English
safety instructions
1
Carefully and fully read the user manual prior to using the
appliance and carefully store the manual for future reference.
• Only use this appliance for the purposes described in the instruction.
Caution: never insert fingers or objects into the ventilation grid when
the appliance is switched on.
• Only connect the appliance to alternate current, with a mains
voltage that corresponds with the information provided on the
information plate of the appliance.
• Never bend the power cord sharply or allow it to run across hot parts.
• Fully unwind the cord to prevent it from overheating.
• Never place the appliance near appliances that give off heat, such
as ovens, gas cookers, hotplates, etc. Keep the appliance away from
walls or other objects that could catch flame, such as curtains,
towels (cotton or paper, etc.).
• Always make sure the appliance is placed on an even, flat surface.
• Only use the appliance indoors.
• Do not leave the appliance unsupervised if the appliance is
operational.
• If you want to move the appliance, make sure the appliance is
switched off.
• Do not use the appliance if the plug, cord or appliance are damaged,
or if the appliance no longer functions properly or if it is damaged in
any other way. If this is the case, consult the shop or our technical
service.
• If the cord of the appliance is damaged, it should be replaced by the
manufacturer, his customer service or a similarly qualified person in
order to prevent hazardous situations.
• Never replace the plug or cord yourself. Repairs to electrical
appliances should only be performed by skilled persons. Incorrect
repairs could cause considerable hazards for the user.
• Never use the appliance with parts that are not recommended or
supplied by the manufacturer.
• Do not pull the cord and/or appliance to remove the plug from the
wall socket. Never touch the appliance with wet or moist hands.
• Never connect the appliance to an external timer or a separate
remote control system, in order to prevent hazardous situations.
• Keep the appliance out of reach of children. Children do not see the
10 English
English 11
dangers when handling electrical appliances. Therefore, never allow
children to work with electrical appliances without supervision. Keep
the appliance and cord out of reach of children younger than 8 years
of age.
• The appliance can be used by children of 8 years and older and
persons with a limited physical, sensory or mental capacity or
lack of experience or knowledge, provided they use the appliance
under supervision or have been instructed about its safe use and
understand the hazards involved.
• Children are not allowed to play with the appliance.
• The appliance may not be cleaned or maintained by children, unless
this is done under supervision.
• If the appliance is not being used or is being cleaned, fully switch off
the appliance by removing the plug from the socket.
• Extension cords may only be used if the mains voltage (see the
information plate) and capacity are identical to or higher than that of
the appliance. Always use an approved extension cord.
• If you decide not to use the appliance any more due to a defect, we
recommend cutting off the cord after removing the plug from the
wall socket. Take the appliance to the waste processing department
concerned of your municipality.
Never submerge the appliance, cord or plug in water.
This appliance is intended for household and similar use, such as:
- in staff kitchens, shops, offices and other
work environments;
- by guests of hotels, motels and other residential environments;
- in Bed&Breakfast type environments;
- farms.
• If the appliance is not used as intended, no compensation can be
claimed in case of defects or accidents and the warranty will be
invalidated.
If you decide not to use the appliance any more due to a defect,
we recommend cutting off the cord after removing the plug
from the wall socket. Small household appliances do not belong
in the dustbin. Take the appliance to the waste processing
department concerned of your municipality.
assembly instructions
2
Before using the fan for the first time, please proceed as follows: carefully unpack the appliance and all components and remove all
packaging material and any promotional stickers. Keep the packaging (plastic bags and cardboard) out of the reach of children. After
unpacking the appliance, check it for external damage that may have occurred during transport.
Assemble the fan in accordance with the instructions.
In order to make the assembly process more easy, we recommend removing components [ a ] and [ b ] before you start.
1. Start by placing the footplate at the pedestal. Align the pedestal with the groove on the footplate and attach them to one another
with the hook bolt [ b ] .
2. Place the motor section on the pedestal and fasten it with screw [ a ].
3. Place the rear protective guard on the fan.
4. Fasten it by tightening the lock ring.
5. Insert the fan blade onto the fan. Test the fan blade by rotating it by hand. During rotation,
the blade should not create any friction with the lock ring. If it does, remove the fan and repeat all steps from the beginning.
6. Mount the fan blade with the fastening cap. Tighten the fastening cap by turning it to the left - counter-clockwise.
7. Place the front protective guard on the fan and use the clamps to attach it to the rear protective guard.
- Align the front protective guard with the rear protective guard using the positioning clamp [ c ] on the
bottom side in order to attach both parts to each other properly. Use the bolt and nut at the top of the guards to fasten the
guards to each other.
- Press the clamps [ d ] downwards in order to fasten the front and rear protective guards to each other.
4
5
6
7
1
2
3
Protective guard - front
Protective guard - rear
Fan blade
Lock ring
Fastening cap
Motor
Pedestal
Footplate
a
b
d
d
b
d
d
d
c
bolt and nut
12 English
The range of the remote control is approx. 5 metres at an angle of 30° in front of the fan.
Insert the two supplied AAA 1.5 Volt batteries in the remote control, as indicated in the drawing.
Do take the plus and minus symbols on the inside of the remote control into account.
The remote control has the same function keys as the fan’s control panel.
Place the fan on a flat, stable surface. Insert the plug in a wall socket.
Turning the fan on and off
Press the ON
/
OFF [ AAN
/
UIT ] key to switch on the fan. By pressing the key once more, you switch off the appliance.
Setting the speed
With every press on the SPEED [ SNELHEID ] key you change the speed of the fan:
low
medium
high
Setting the timer
Press the TIMER key to start the timer. The time period is increased in steps of 1 hour when you repeatedly press this key, up to a
maximum of 7 hours.
For example, if you want to set the fan to 5 hours, press this button until the two indicator leds light up, 1u + 4u = 5 hours. The fan will
switch off when the entire programme has been completed.
If you want to stop the timer function or set a new time, you must continue to press the TIMER key until all indicator leds are off.
Oscillation
This fan is able to oscillate (swerve to the left and right) for a better air displacement.
If you want to change the wind to an upward or downward direction, you can simply move the fan head upwards or downwards.
Place the fan on a flat, stable surface. Clean the exterior of the fan using a slightly damp cloth and then wipe it with a dry cloth.
The fan is ready for use.
using the fan
3
batteries
speed
timer
on/off
English 13
cleaning and maintenance
4
Before cleaning the fan, you must switch it off with the ON
/
OFF key [ AAN
/
UIT ] and remove the plug from the socket.
Wipe the exterior of the appliance with a slightly damp cloth and dry properly.
If necessary, you can clean the protective guard using a vacuum cleaner (nozzle).
Do not use aggressive or abrasive cleaning agents for cleaning the appliance.
Never submerge the fan in water or any other liquid.
Adjusting the height of the pedestal
In order to adjust the height, loosen the pedestal adjustment nut and move the fan upwards or downwards. Properly hold on to the fan
when loosening the pedestal adjustment nut, so it cannot drop down unexpectedly. Re-tighten the pedestal adjustment nut when the
fan is at the required height.
Push in the oscillation pen to allow the fan to
oscillate.
If you want to stop the oscillation, simply pull out
the pen.
oscillation pen
manual tilting
operation
Adjusting the height of the
pedestal
14 English
We do not need to remind you of the importance of service. After all, we develop our products to a standard so that you
can enjoy them for many years, without any concerns. If, nevertheless, there is a problem, we believe you are entitled to a
solution straight away. Hence our products come with an exchange service, on top of the rights and claims you are entitled to
by law. By exchanging a product or part, we save you time, effort and costs.
2-year full manufacturer’s warranty
1. Customers enjoy a 2-year full manufacturer’s warranty on all Inventum products. Within this period, a faulty product or part will
always be exchanged for a new model, free of charge. In order to claim under the 2-year full manufacturer’s warranty, you can either
return the product to the shop you bought it from or contact the Inventum costumer service department via the form at www.
inventum.eu/service-aanvraag.
2. The 2-year warranty period starts from the date the product is bought.
3. In order to claim under the warranty, you must produce a copy of the original receipt.
4. The warranty applies only to normal domestic use of Inventum products within the Netherlands.
Breakdowns or faults outside the warranty period
1. Breakdowns or faults in small or large domestic appliances outside the warranty period, can be reported to the costumer services
department via the form at www.inventum.eu/service-aanvraag or by calling the costumer services department.
2. The costumer services department may ask you to send the product for inspection or repair. The costs of dispatch will be at your
expense.
3. The inspection to establish whether repair is possible involves a charge. You need to grant your permission for this, in advance.
4. In the event of a large domestic appliance, Inventum, at your request, can send out a service engineer. In that case, you will be
charged the call-out costs, as well as parts and labour.
5. In the event of an instruction to repair, the repair costs must be paid in advance. In the event of a repair by a service engineer, the
costs of the repair must be settled with the engineer onsite, preferably by means of PIN payment.
Warranty exclusions
1. The following is excluded from the aforesaid warranties:
normal wear and tear;
improper use or misuse;
insufficient maintenance;
failure to comply with the operating and maintenance instructions;
unprofessional installation or repairs by third parties or the customer himself;
non-original parts used by the customer;
use for commercial or business purposes;
removal of the serial number and/or rating label.
2. In addition, the warranty does not apply to normal consumer goods, such as:
dough hooks, baking tins, (carbon) filters, etc.;
batteries, bulbs, carbon filters, fat filters etc.;
external connection cables;
glass accessories and glass parts such as oven doors;
and similar items.
3. Transport damage not caused by Inventum is also excluded. Therefore, inspect your new device before starting to use it. If you
detect any damage, you must report this to the store where you purchased the product within 5 working days, or to the Inventum
customer service department via the form at www.inventum.eu/service-aanvraag. If transport damage is not reported within this
period, Inventum does not accept any liability in this respect.
4. The following are excluded from warranty and/or replacement: faults, loss of and damage to the device as a result of an event that
is normally insured under the home contents insurance.
Important to know
1. The replacement or repair of a faulty product, or a part thereof, does not lead to an extension of the original warranty period.
2. If a complaint is unfounded, all costs arising from it will be at the customer’s expense.
3. Following expiry of the warranty period, all costs of repair or replacement, including administration costs, dispatch and call-out
charges, will be charged to the customer.
4. Inventum cannot be held liable for damage caused by external events, unless this liability arises from mandatory statutory
provisions.
5. These warranty and service provisions are governed by Dutch law. Disputes will be settled exclusively by the competent Dutch
court.
general terms and conditions of service and warranty
28 English
VST412BA/01.0119V
Wijzigingen en drukfouten voorbehouden/ Änderungen und Druckfehler vorbehalten/
Sous réserve de modification / Modifications and printing errors reserved
Inventum Huishoudelijke
Apparaten B.V.
Meander 901
6825 MH Arnhem
T 0800 -4583688
info@inventum.eu
www.inventum.eu
twitter.com/inventum1908
facebook.com/inventum1908
youtube.com/inventum1908
persoonlijke verzorgingklein huishoudelijk witgoed inbouwwitgoed vrijstaand
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32

Inventum VST412BA Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI