Page is loading ...
ENJOYBOT
ELECTRIC SCOOTER
USER S MANUAL‘
H3/H3 PRO
USAGE
SPECIFICATION
CHARGING THE BATTERY
ASSEMBLE AND SET UP
WARNING
CAUTIONS
WHAT S IN THE BOX
‘
TABLE OF CONTENT
1
2
3
4-5
6
8-9
7
11
10
12
WARRANTY
13
RISK OF DEATH OR SERIOUS INJURY
Riding an electric scooter are intended to move and it is therefore possible to get into dangerous situations and/or lose
control and/or fall. If such things occur you can be seriously injured or die. Like any other moving product, using electric
scooter can get you into dangerous situations and may result in injury or death even when use with proper safety
precautions, use at your own rish and use common sense.
1Page
The recommended minimum rider age is 14 and older. Any rider unable to fit comfortably on the scooter should not attempt
to ride it. A parent’s decision to allow his or her child to ride this product should be based on the child’s maturity, skill and
ability to follow rules.
Keep this product away from small children and remember that it is intended for use only by persons who are, at a minimum,
completely comfortable and competent while operating the scooter.
Always wear a helmet when riding. Avoid water, wet surfaces, slippery/uneven surfaces, steep hills, traffic, cracks, tracks,
gravel, rocks, or any obstacles that could cause a loss of traction and cause a fall. Avoid riding at night, poorly lit areas,
and small spaces.
INSTRUMENT INTRODUCTION
Keep fingers , hair, and clothing away from belts, motors, wheels, and all moving parts.
WARNING: WATCH OUT FOR WATER!
WARNING: POTENTIAL DANGERS!
ENJOYBOT is not water proof. Electronics, bearings, and other components can damaged, Water
damage ia not covered under the warranty.
WARNING: DANGER OF ELECTRLC SHOCK!
Do not open or tamper with electronics housings, which also voids the warranty.
GO ANYWHERE: Please be responsible and respectful of others when riding for your safety.
TURN ON/OFF THE LIGHT
REPAIR AND MAINTENANCE
WARNING
HandlebarCharger User
’
s Manual Hexagon Wrench
CAUTIONS WHAT S IN THE BOX‘
3Page
2Page
ENJOYBOT
Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect the
contents of the box for scratches in the paint, dents that may have occurred during shipping. Because the scooter was 98%
percent assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents.
Please keep this box in case you need to send the scooter for service or repairs. If you use another box, ENJOYBOT will not be
responsible for any damage caused during shipping.
Estimated Assembly and Set-Up Time
Allow up to 2 minutes for assembly, not including initial charge time.
SLIPPING HAZARDS:
TRIPPING HAZARDS:
COLLISION HAZARDS:
ENJOYBOT
ELECTRIC SCOOTER
USER S MANUAL‘
H3/H3 PRO
ASSEMBLE AND SET UP
4
Page
5
Page
Tightening the handlebar one by one.
Handlebar Assemble
ASSEMBLE AND SET UP
Folding the Scooter
1.Press the folding bar with hands.
1.Hold the handlebar stem and
pull the folding bar slightly.
2.Push down the handlebar stem slightly. 3.Folded finished after hearing a click.
2.Stand up the handlebar stem. 3.Unfolding finished after hearing a click.
Unfolding the Scooter
Folding hole
Km/h
WARNING:
!
Always do not insert the finger in the foldng hole,
it will make the finger in injury even cut off.
7Page
6Page
INSTRUMENT INTRODUCTION
Capacity Display
Level Display
Power Switch
Speed Display
Up Button
Down Button
Range Display
Range Data
Charging Port
Hand Brake
Throttle Control
Km/h
DIS
Detachable Handlebar
Detachable Handlebar
CHARGING THE BATTERY
Your electric scooter may not have a fully charged battery; therefore you must charge the battery prior to use.
Charge time: Approx. 2hrs for H3 or 5hrs for H3 Pro when the light turns green.
Always charge the battery immediately when the capacity is below 2levels.
Unplug charger from the wall outlet when not in use.
To ensure long battery life, never store the product in freezing or below freezing temperatures! Freezing will permanently
damage the battery.
Battery life can vary depending on proper maintenance and usage of the unit.
1. Plug the charger plug into wall outlet. The light on the charger should be green.
Note: If green light (LED) does not turn on, try a different outlet.
WARNING: Use ONLY with the recommended charger. Batteries are only to be charged under adult supervision. The charger
is not a toy. Always disconnect the charger before wiping down and/or cleaning the electric scooter with a damp cloth.
Note: If the charger gets warm during regular use, this is a normal response and is no cause for concern. If your charger
does not get warm During use, it does not mean that it is not working properly.
2.Plug the charger into the charger port. Make sure the power
switch is in the OFF position. The light on the charger should
turn red during charging. The light will turn green again when
charging is complete.
9Page
8Page
Always wear a helmet when riding.
USAGE
Stopping the Scooter
Release the Throttle Control and apply the hand brake and foot brake until scooter comes to a complete stop.
USAGE
Starting the Scooter
Press and hold the power switch for 3seconds to ON/OFF, place both hands on the handlebars.
Place one foot on the deck plate, press the Throttle Control. Place other foot on deck plate once motor has engaged.
10Page
SPECIFICATION
11Page
Model
Dimension
Battery Informaiton
Motor
Charger
Weight
Function
Temperature Range
H3 / H3 Pro
Unfolding Size 36.2*15.9*39.3inch
Folding Size 39.3*15.9*9.3inch
Tire Size 5inch
Max. Load 220lb
Max. Speed 16mph
Climbing Height 20
Max. Distance 8miles /18miles
Type Lithium Ion Battery
Capacity 24V 96Wh/249Wh
Power 250W
Voltage 24V
Input AC100-240V
Output DC 29.4V 2A
Charge Time Approx.2hrs/5hrs
Net Weight 14.9lb/16.7lb
Gross Weight 17.6lb/19.8lb
Charge Temperature 0~45
Discharge Temperature -10~55
Storage Temperature 10~40
TURN ON/OFF THE LIGHT
Press the button to turn on/off the light
C
C
C
12Page 13Page
CLEANING YOUR SCOOTER
Wipe with a damp cloth to remove dirt and dust. Do not use industrial cleaners or solvents as they may damage the
surfaces .Do not use alcohol, alcohol-based or ammonia- based cleaners as they may damage or dissolve the plastic
components or soften the decals or decal adhesive.
WHEELS AND BEARINGS
Under normal circumstances and conditions, ENJOYBOT wheels and wheel bearings are maintenace free. Nonetheless, it is
the responsibility of the owner or guardian to periodically inspect the wheels for wear and tear,the axle for proper
tightness, and bearings for side-to-side play, and loose parts. When a wheel or wheel bearing develops play, this is an
indication of excess wear replacement is necessary.Replace immediately with only genuine ENJOYBOT wheels. Worn
wheels/bearings are considered normal wear-and-tear and are not covered by the ENJOYBOT Warranty. Warranty. Wheels
other than genuine ENJOYBOT wheels may not be compatible with your ENJOYBOT scooter.The use of anything other
than genuine ENJOYBOT replacement parts may affect your safety and will void your warranty.
REPLACEMENT PARTS
The most frequently requested replacement parts are available for purchase at some ENJOYBOT retail partners. For the
complete selection of replacement parts visit www.enjoybot.com.
REPAIR AND MAINTENANCE
The ENJOYBOT is covered under a one year limited warranty.The warranty begins from the original purchase date.The
warranty covers manufactrer's defects in material or workmanship that arises under normal use for one year. Proof of
purchase in the form of the original purchase order or packaging slip is required for warranty validation and
reimbursement.Warranty claims must be made directly to ENJOYBOT.
If a defect arises and a valid claim is received within the warranty period, ENJOYBOT will repair the defect by using new
or refurbished parts that is equivalent to new in performance and reliability or exchange the product with a product
that in new or refurbished that is equivalent to the original product. Any attempts to modify, repair, or replace the unit
or any components of within he device will result in voiding any warranty and lead to malfunctions which may cause
serious personal injury.
This product is not a toy and is not intended to be used by children.Minors should use it only ubder the direct
supervision and responsibility of an adult.For your own safety,please read the manual carefully and thoroughly before
operating the device.Operate only in legally designated areas.Refer to local laws before operating device.
This device is offered with a limited one-year warranty. The warranty covers material or workmanship defects that arise
with your product due to a manufacturers defect. Proof of purchase in the form of the original purchase ordrer or
packaging slip is required for warranty validation and reimbursement.
WARRANTY
/
