THIS PAGE INTENTIONALLY LEFT BLANK
2. The Handle
3. Refrigerator Door
4. Leveling Feet
4
1. Top Hinge
1.
2.
3. Drip Tray
4. Shelf
5.
6. Door Gasket
7. Soda Can Storage
Thermostat Control Knob
Chiller Compartment
Bottle Storage
5
chiller is located at the upper right hand
orner of the
chiller compartment.
The first time you turn the unit on, adjust the
thermostat control knob to 3 and give your
refrigerator time to cool down completely
After it is fully cooled, test it and adjust
owards 1 to make less cool or towards 6 to
c
recommended.
before adding food; a full 24 hours is
t
cool more to best suit your needs. However,
the setting of 3 should be appropriate for
home or office refrigerator use.
DEFROSTING
1
.
2
To avoid to yourself and/or property, we recommend someone assist you during the door
reversal process.
injury
NOTE:
To take the door off it is necessary to tilt the
Appliance backward. You should rest the
Appliance on something solid, e.g. a chair just
below the top panel.
DO NOT lay
the Appliance completely flat as
this may damage the coolant system.
• Ensure the Appliance is unplugged and empty.
• Adjust the two leveling feet to their highest
position.
• We recommend you have someone to assist
you.
• 8mm socket screw driver
• Phillips style screw driver
1. Upper Hinge Bracket
2. Adjustable Leveling Foot
3. Machine Screw
4. Bottom Hinge Bracket
5. Level Foot
Remove the upper hinge cover, then unscrew the upper screws of metal hinge bracket and take off
the hinge. Then take off the left side screw cover. Pull the appliance door upward to take it off.
At the same time, remove the mounting screws next to left leveling foot .
Remove left leveling foot and the bottom hinge bracket by unscrewing the mounting screws.
REVERSING THE DOOR POSITION
4
3
BOTTOM VIEW
Install the leveling foot and the bottom hinge bracket on the new bottom side. Then tighten the
screws of the bottom hinge bracket.
Slot in the appliance door into the bottom hinge pin. Replace the upper hinge bracket on the new
side and check the fitting between the door/ hinge moving smoothly. Then tighten the screws of
upper hinge bracket. Replace the hinge cover and the right side screw cover.
Check that the door is aligned horizontally and vertically and that the seals are closed on all
sides before finally tightening the upper hinge. Re-adjust the leveling feet.
0.8A
214 kwh
AC115V 60Hz 84W
4071099
PART NO.: ER103002-20170623-0
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Emerson CR275BSE2 Owner's manual
-
-
-
-
-
-
-
-