27 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 834862
834862 ProClip
Console mount, NOT for models with manual gearshift or Anniversary Edition models.
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288348629
Item no 834862 fits:
Infiniti G37 Coupe 08-13 (For USA)
Infiniti G37 Sedan 09-13 (For USA)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the ProClip.
1. Press the thin end of the enclosed gap openers into the gap between the center console panel frame and the
console edge, to widen it. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed.
Peel off the cover of adhesive tape on the ProClip.
2. Align the front part of the ProClip as shown in the picture. Press the angled edge on the right part of the
ProClip into the gap between the gap openers.
3. Press firmly down on the left part of the ProClip so the angled edge hooks around the console sidewall edge by
the floor carpet. Press until you see or hear/feel it snaps into place. Pull out the gap openers.
4. The ProClip is in place.
2(2)
-
1
-
2
