Fixing nut
O-ring
Mixer body
Thread pipe
Waterlines
We do NOT recommend to use any household cleaners to clean the
product. The product should be cleaned only with soapy water and rinsed
with clean water and dried with a soft cloth.
For more details please visit www.rivuss.com/support
1: Screw the waterlines into the inlet pipe of the faucet body, fit rubber
washer into the groove of the faucet body.
2: Pass waterlines and thread pipe through the table hole. Then twist
the fixing nut to the thread pipe. Adjust the mixer body and fix firmly.
Aerator
Cleaning
Maintenance
•
Before use: Unscrew the Aerator and allow the water to run freely for 5
minutes. Then screw the filter back in place.
•
Periodically: Unscrew the Aerator and remove. Rinse it with running
water until any loose debris is cleared. Then replace the Aerator and
tighten.
Shut off main water supply before main installation
Contact us at Toll Free 1-855-5RIVUSS or visit our website www.rivuss.com © 2013 - 2015 Rivuss USA Contact us at Toll Free 1-855-5RIVUSS or visit our website www.rivuss.com © 2013 - 2015 Rivuss USA