2. GuardAir
  3. HYD024SSA

GuardAir HYD024SSA User guide

  • Hello! I've reviewed the maintenance instructions for the Air gun. This document outlines the necessary steps for disassembling, cleaning, and reassembling the gun, including instructions on how to remove and lubricate the o-rings. If you have questions about this process or any other aspect of the gun's maintenance, feel free to ask!
  • What may be needed to loosen the thread locker?
    What tool is necessary to remove spring and shuttle?
    What should be used to clean threads?
    What should o-rings be lubricated with?
Maintenance Instructions
1. Unscrew extension from handle. Thread locker was applied to threads at
factory therefore heat may be required to loosen thread locker.
2. Remove spring and shuttle from handle using provided tool.
3. Remove o-ring from extension.
4. Throughly clean threads of extension and threads and ID of handle.
Use of acetone or equivalent evaporating solvent recommended.
5. Install new o-ring onto extension. Lubricate with o-ring lube.
6. Lubricate o-rings of shuttle with o-ring lube. Do not scratch ID of
handle, this is an o-ring surface.
7. Install shuttle and then spring into handle.
9. Thread extension into handle. Gun can be used immediately.
Maintenance Instructions
1. Unscrew extension from handle. Thread locker was applied to threads at
factory therefore heat may be required to loosen thread locker.
2. Remove spring and shuttle from handle using provided tool.
3. Remove o-ring from extension.
4. Throughly clean threads of extension and threads and ID of handle.
Use of acetone or equivalent evaporating solvent recommended.
5. Install new o-ring onto extension. Lubricate with o-ring lube.
6. Lubricate o-rings of shuttle with o-ring lube. Do not scratch ID of
handle, this is an o-ring surface.
7. Install shuttle and then spring into handle.
9. Thread extension into handle. Gun can be used immediately.
Maintenance Instructions
1. Unscrew extension from handle. Thread locker was applied to threads at
factory therefore heat may be required to loosen thread locker.
2. Remove spring and shuttle from handle using provided tool.
3. Remove o-ring from extension.
4. Throughly clean threads of extension and threads and ID of handle.
Use of acetone or equivalent evaporating solvent recommended.
5. Install new o-ring onto extension. Lubricate with o-ring lube.
6. Lubricate o-rings of shuttle with o-ring lube. Do not scratch ID of
handle, this is an o-ring surface.
7. Install shuttle and then spring into handle.
9. Thread extension into handle. Gun can be used immediately.
Maintenance Instructions
1. Unscrew extension from handle. Thread locker was applied to threads at
factory therefore heat may be required to loosen thread locker.
2. Remove spring and shuttle from handle using provided tool.
3. Remove o-ring from extension.
4. Throughly clean threads of extension and threads and ID of handle.
Use of acetone or equivalent evaporating solvent recommended.
5. Install new o-ring onto extension. Lubricate with o-ring lube.
6. Lubricate o-rings of shuttle with o-ring lube. Do not scratch ID of
handle, this is an o-ring surface.
7. Install shuttle and then spring into handle.
9. Thread extension into handle. Gun can be used immediately.
/