Silvercrest 285323 Owner's manual

Brand: Silvercrest

Model: 285323

Category: Power banks

Type: Owner's manual

Silvercrest 285323 is a mobile, highly efficient power bank designed to charge USB-enabled devices such as smartphones, tablets, and portable music players. It features a compact and lightweight design, making it easy to carry and use on the go. With its generous battery capacity, it provides multiple charges for various devices before requiring a recharge. The power bank comes with multiple safety features, including protection against overcharging, over-discharging, and short circuits, ensuring safe charging of your devices.

DESIGNER POWER BANK

CARGADOR CENTRAL

SPBW 3000 A1

IAN 285323

DESIGNER POWER BANK

Operating instructions

CARGADOR CENTRAL

Instrucciones de uso

US - EN Operating instructions Page 1

US - ES Instrucciones de uso Página 25

Before reading, unfold the page containing the

illustrations and familiarise yourself with all functions

of the device.

Antes de empezar a leer abra la página que con-

tiene las imágenes y, en seguida, familiarícese con

todas las funciones del dispositivo.

SPBW 3000 A1 US-EN │ 1 ■

Contents

Introduction ........................3

Information about these operating

instructions .............................. 3

Intended use ............................. 4

Warnings used ........................... 4

Safety ............................6

Basic safety instructions .................... 6

Descriptions of components ..........10

Start-up ..........................10

Check scope of delivery ................... 10

Disposal of packaging materials ............ 11

Charging the Power Bank .................. 12

Checking the charge level ................. 13

Handling and operation .............14

Charging mobile devices with the Power Bank . 14

Troubleshooting ...................15

Cleaning. . . . . . . . . . . . . . . . . . . . . . . . . .16

Storage when not in use ............17

SPBW 3000 A1

■ 2 │ US-EN

Disposal ..........................17

Appendix .........................18

Technical data .......................... 18

FCC Compliance Statement ................ 19

Warranty .............................. 21

Distributor .............................. 23

SPBW 3000 A1 US-EN │ 3 ■

Introduction

READ ALL INSTRUCTIONS BEFORE USE

Information about these operating

instructions

Congratulations on the purchase of your new device.

■ You have selected a high-quality product.

■ The operating instructions are part of this product.

■ They contain important information about safety,

use and disposal.

■ Before using the product, please familiarize your-

self with all operating and safety instructions.

■ Use the product only as described and for the

range of applications speciﬁed.

■ Retain these instructions for future reference.

■ Please also pass these operating instructions on

to any future owner.

USB® is a registered trademark of USB Implementers

Forum, Inc.

All other names and products may be trademarks or

registered trademarks of their respective owner.

SPBW 3000 A1

■ 4 │ US-EN

Intended use

■ This device is an information technology device and

is intended exclusively for charging mobile devic-

es that are charged via a USB port as standard.

■ The device is not intended for any other purpose,

nor for use beyond the scope described.

■ The device is not intended for use in commercial

or industrial environments.

■ The manufacturer accepts no responsibility for

damage caused by failure to observe these in-

structions, improper use or repairs, unauthorized

modiﬁcations, or the use of unapproved replace-

ment parts. The risk is borne solely by the user.

Warnings used

The following warning types are used in these

operating instructions:

► WARNING indicates a hazardous situation which,

if not avoided, could result in death or serious

injury.

SPBW 3000 A1 US-EN │ 5 ■

► CAUTION indicates a hazardous situation which,

if not avoided, could result in minor or moderate

injury.

► NOTICE indicates information, which is conside-

red important, but not hazardous (e. g. messages

related to property damage).

A "Tip" indicates additional information that will

assist you in using the device.

You will ﬁnd this symbol on the power bank

housing.

► The Power Bank must never be charged and used

for charging an external device at the same time.

► Use only a USB mains adapter with an output

voltage of 5V and an output current of at least

2.1A to charge the power bank.

SPBW 3000 A1

■ 6 │ US-EN

Terminology

As used in this instruction manual in general and

with regard to safety information and warnings,

the following words are assumed to mean:

■ May: This word is understood to be permissive.

■ Shall: This word is understood to be mandatory.

■ Should: This word is understood to be advisory.

Safety

This section contains important safety instructions

for hand ling the device. This device complies with

statutory safety regulations. Improper use may result

in personal injury and property damage.

Basic safety instructions

■ Never open the device

housing. None of the components in the device

can be serviced or replaced by the user.

■ Risk of suﬀocation!

Do not allow children to play with the packaging

material! Keep all packaging materials away from

children.

SPBW 3000 A1 US-EN │ 7 ■

■ All repairs must be carried

out by authorized service centers or by the

customer service department. Improper repairs

may put the user at risk. It will also invalidate any

warranty claims.

■ Improper use of the batteries

can cause ﬁres, explosions, leakages or other

hazards! Do not throw the device into a ﬁre as

the integrated battery could explode.

■ Always place the device on

a stable and level surface. It can be damaged if

dropped.

■ Do not operate the device

close to open ﬂames (e.g. candles).

■ Do not expose the device

to direct sunlight or high temperatures and do

not cover it during charging. Otherwise, it may

overheat and be irreparably damaged. This

particularly applies to storage in a car. Extreme

temperatures can occur in car interiors and glove

compartments during long periods of immobili-

zation. Remove electrical and electronic devices

from the vehicle.

SPBW 3000 A1

■ 8 │ US-EN

■ Check the device for visible external damage be-

fore use. Do not operate a device that has been

damaged or dropped.

■ This device may be used by children aged 8

years and above and by persons with limited

physical, sensory or mental capabilities or lack of

experience and knowledge. Only, if it is provided

that they are under supervision or have been told

how to use the device safely and are aware of

the potential risks.

■ Children must not play with the device.

■ Cleaning and maintenance shall not be carried

out by children unless they are supervised.

■ Do not place the product near heat sources such

as radiators or other heat-generating devices.

■ The device is not designed for use in rooms with

high temperatures or humidity (e.g. bathrooms) or

where there is excessive dust.

■ Do not use the device immediately after moving it

from a cold room to a warm room. Always allow

the device to acclimatize before turning it on.

■ Do not make any unauthorized modiﬁcations or

alterations to the device.

SPBW 3000 A1 US-EN │ 9 ■

■ Do not expose the device to water spray or drip-

ping water, and do not place liquid-ﬁlled objects

such as vases or open drink containers on or near

the device.

■ Turn the device oﬀ immediately and disconnect

any connected charging cables from the device

if you smell fumes, or notice any smoke. Have the

device checked by a qualiﬁed specialist before

using it again.

■ If you are using a USB power supply, the socket

you use must always be easily accessible so that

the USB power supply can be quickly disconnect-

ed from the socket in a hazardous situation. You

should also observe the operating instructions for

the USB power supply.

■ Note any restrictions or prohibitions on use for

battery-powered appliances in locations with spe-

ciﬁc hazard risks, such as gas stations, airplanes,

hospitals, etc.

SPBW 3000 A1

■ 10 │ US-EN

Descriptions of components

(See fold-out page for illustrations)

Power Bank SPBW 3000 A1 (model example)

microUSB charging port (input)

USB port (output)

ON/OFF button

Charge level LEDs

Charging cable (USB to microUSB)

Operating instructions (Symbol image)

Start-up

Check scope of delivery

(See fold-out page for illustrations)

The scope of delivery includes the following

components:

▯ Designer Power Bank SPBW 3000 A1

▯ Charging cable

▯ These operating instructions

♦ Remove all parts of the device from the packaging

and remove all packaging materials.

SPBW 3000 A1 US-EN │ 11 ■

Check the package for completeness and for signs

of visible damage.

If the delivery is incomplete or damage has oc-

curred as a result of defective packaging or during

transport, contact the Service hotline (see chapter

entitled Warranty).

Disposal of packaging materials

The packaging protects the device from

damage during transport. The packaging

materials have been selected for their

environmental friendliness and ease of

disposal, and are therefore recyclable.

Returning the packaging into the material cycle con-

serves raw materials and reduces the amount of

waste generated. Dispose of packaging materials

that are no longer needed in accordance with

applicable local regulations.

SPBW 3000 A1

■ 12 │ US-EN

Charging the Power Bank

Before using the Power Bank, the integrated battery

must be fully charged.

► The Power Bank must never be charged and used

for charging an external device at the same time.

► Due to the high battery capacity and bearing in

mind the charging time, the power bank must be

charged using a USB mains adapter.

► Use only a USB mains adapter with an output

voltage of 5V and an output current of at least

2.1A to charge the power bank.

♦ Connect the USB plug of the charger cable

to a USB mains adapter (not supplied).

♦ Connect the microUSB plug of the charging cable

to the microUSB charging port on the

Power Bank. An estimate of the charge level is

shown by means of the charge level LEDs .

SPBW 3000 A1 US-EN │ 13 ■

LED display Charge level

One LED is ﬂashing < 20%

One LED is on, the second LED

is ﬂashing 20–49%

Two LEDs are on, the third LED

is ﬂashing 50–74%

Three LEDs are on, the fourth LED

is ﬂashing 75–97%

All LEDs are on 98–100%

Checking the charge level

You can also check the charge level of the Power

bank when it is not charged or is being used for

charging.

♦ Press the ON/OFF button brieﬂy. The LEDs

show the current charge level of the Power bank

for about 30 seconds.

SPBW 3000 A1

■ 14 │ US-EN

LED display Charge level

All LEDs are on 98–100%

Three LEDs are on 75–97%

Two LEDs are on 50–74%

One LED is on 20–49%

One LED is ﬂashing < 20%

All LEDs are oﬀ 0%

Handling and operation

Charging mobile devices with the

Power Bank

♦ Insert the microUSB plug of the charging cable

into the microUSB charging port of the mobile

device, and insert the USB plug into the USB port

on the Power Bank. The charging process starts

automatically.

♦ If charging does not start automatically, press the

ON/OFF button brieﬂy to start the charging

process.

SPBW 3000 A1 US-EN │ 15 ■

Alternatively, you can also use the original charging

cable (USB cable) provided by the respective device

manufacturer.

♦ During the charging process, the current charge

level of the Power Bank is shown via the charge

level LEDs (see table in chapter entitled

Charging the Power Bank).

♦ To end the charging procedure, disconnect the

charging cable from the mobile device and

the Power Bank. The charging status LEDs go

oﬀ after about 30 seconds.

Troubleshooting

The Power Bank does not charge

♦ Connection may be faulty. Check the connection.

A connected device will not charge

♦ The integrated battery is empty. Charge the battery.

♦ No connection to the device. Check the connection.

♦ Press the ON/OFF button to start the charging

process.

♦ The charging current of the connected device is

too low (< 60 mA) or too high (> 2,1 A).

SPBW 3000 A1

■ 16 │ US-EN

♦ The internal overcurrent protection may have

been triggered. Disconnect the attached device

and connect the microUSB charging port to

a power source for a short while (see section

Charging the Power Bank). Afterwards, the

Power Bank can be used again.

If you cannot solve the problem with the above-men-

tioned solutions, please contact the Service Hotline

(see chapter entitled Service).

Cleaning

There are no serviceable parts or

parts requiring cleaning inside the Power Bank. Mois-

ture can cause damage to the appliance.

► To avoid irreparable damage to the appliance,

ensure that no moisture can penetrate the device

during cleaning.

► Do not use caustic, abrasive or solvent-based

cleaning materials. These can damage the sur-

faces of the device.

♦ Clean the housing of the device with a lightly

moistened cloth and a mild detergent only.

SPBW 3000 A1 US-EN │ 17 ■

Storage when not in use

♦ Store the device in a location which is clean,

dry, dust-free and not in direct sunlight.

♦ For long-term storage, the integrated battery should

be fully charged to extend its operating life.

Disposal

Electronic devices may not be thrown away as part

of normal household trash. If you can no longer use

your electronic device, dispose of it in accordance

with the legal provisions applicable in your state. This

will allow you to ensure that old electronic devices

are recycled and environmental pollution is kept to a

minimum.

Additional information about disposal is available on

the Internet at www.epa.gov.

Page is loading ...

Silvercrest 285323 Owner's manual

Brand: Silvercrest

Model: 285323

Category: Power banks

Type: Owner's manual

Download PDF

report

Silvercrest 285323 Owner's manual

Silvercrest 285323 Owner's manual

Related papers

Other documents