Friedrich KCL24A30A Operating instructions

Hello! I have reviewed the Friedrich Wi-Fi Setup Guide for the Kuhl, Kuhl Q, and Wallmaster air conditioner units. This document outlines the steps for connecting your devices to your Wi-Fi network using the Friedrich Connect app. It also covers initial setup steps and troubleshooting tips. I'm ready to answer any questions you have about setting up your device.
What type of Wi-Fi connection is required?

What app do I need to download?

What should I do after entering the Friedrich Connect app and pressing "+ add"?

What should I do if the setup process takes more than five minutes?

What will happen when the mobile device and the unit successfully communicate?

What indicates a successful connection?

Let's Get Started!

1. Check for a 2.4 Ghz connection and

make sure the device is connected to

that network.

2. Download the Friedrich Connect

App on your smartphone.

3. Sign into the app or create a

account.

4. Verify the profile, check and confirm

that the TIME ZONE is populated

correctly.

5. Enter the Friedrich

connect app and press

"+ add". The app will

automatically show the

next screen. Prepare

your device will pop up,

but DO NOT PRESS

START at this time.

Wi-Fi Setup Guide

FRIEDRICH CONNECT

Kuhl Kuhl Q Wallmaster

6.Go to the unit press the MENU button

and with the arrows go to CNCT and

press MENU again.

NOTE: When the setup process

starts, the WI-FI symbol will begin to

flash. This indicates the A/C unit is

broadcasting its WiFi SSID.

NOTE: Once the setup process has

been started, you will have five minutes

to complete the setup. If the setup

cannot be completed in five minutes

then you will need to restart the

process.

7. Now on the mobile

device go to your

WiFi settings without

ending the Connect

App and connect

to Friedrichconnect

-xxxx SSID (the last 4

characters of the units

MAC address are in the

network name of the

Friedrich unit)

8.Go back to the app

and press START, you

will receive a Looking

for your device screen

until the Unit is found,

DO NOT LEAVE THIS

SCREEN.

9. When the Mobile

device and the Unit

make a successful

communication you will

see the WiFi network

selection screen. Your

WiFi Network must be

in the select dropdown,

if it is not then press the

Retry Button (this will

refresh the listings and

add in your network).

Press Next, and enter

the SSID password and

press Next again.

Note: The option to Enter credentials

manually does not work. If all steps

are performed properly and no SSIDs

populate in the app but they are

populated in the mobile devices WiFi

listings, then the unit is not on the latest

Firmware and will need a new User

Interface.

10. The next window

will show connected

success. Just press OK,

and you will see the

new unit in devices with

the serial number of the

device as its name that

can be changed in the

units Info Tab.

NOTE: If any step is deviated, the

connection will not happen but Success

will still display.

NOTE: Your Home Screen Wi-Fi

symbol will stop flashing and will show

steady

NOTE: A GREEN symbol will appear

under the "Status" details and the

name of your Friedrich unit which will

appear with a number. for example:

(62601032R01184660025)

11. Last step when you

see the serial number

under "MY DEVICES"

you can select the unit

and verify if is working,

press MODE to change

the temperature.

NOTE: Sometimes it

takes a few seconds for

the command to register

on the unit.