95 Sherwood Avenue. Farmingdale, NY 11735 Phone: (888) 353-2634 Fax: (631) 531-8811
www.amdi.net Page 1 of 2 888.353.2634
Instructions on how to setup the iAdapter™ Bluetooth® Audio
The following instructions are for Apple’s iOS 7 or 8 and the built-in accessibility options. For users still
utilizing Apple’s iOS6 or older, please see information on how to utilize our Bluetooth switch at the end of this
manual.
iAdapter 5, 5A and 5A2
Power OFF/ON Switch Bluetooth LED Charging LED
Power OFF/ON Switch – This switch turn the power onto the amplifier and the Bluetooth audio
module that will sync with the iPad
®.
Bluetooth LED – This LED is used to indicate the status of the module. When flashing rapidly the
module is in pairing discovery mode, which means it is looking to sync with a device.
Charging LED – This LED will turn on when the USB charging plug is plugged into the USB charging
port. It will light RED.
The Bluetooth module works off of the existing internal battery of the iAdapter. If the internal battery of the
iAdapter loses power or if the Power switch turn set to the OFF position the Bluetooth module will turn off. As
soon as power is restored the Bluetooth module will sync with the iPad again.
95 Sherwood Avenue. Farmingdale, NY 11735 Phone: (888) 353-2634 Fax: (631) 531-8811
www.amdi.net Page 2 of 2 888.353.2634
Syncing the Bluetooth Audio to your iPad
1. Select the General Settings icon and then select Bluetooth to make sure it is on.
2. Turn the Bluetooth module into Sync mode by sliding the Power Switch to the ON position on the right
side of the iAdapter. You will see the blue LED light flashing rapidly.
Power OFF/ON Switch Bluetooth LED
3. At this point you should see the Bluetooth module come up on the device list (i.e. i5.01).
4. To sync the module to your iPad, at this point all you need to do is simply select the i5.01 device and the
iPad will automatically sync. No code is required.
/
