EZ-FLO 10025LF is a dual control lavatory faucet designed for easy installation and long-lasting use. It features metal handles with hot and cold indices, a locking nut for secure mounting, and a spout with an aerator for a steady water flow. The faucet is backed by a limited lifetime warranty for added peace of mind.
EZ-FLO 10025LF is a dual control lavatory faucet designed for easy installation and long-lasting use. It features metal handles with hot and cold indices, a locking nut for secure mounting, and a spout with an aerator for a steady water flow. The faucet is backed by a limited lifetime warranty for added peace of mind.
These are general installation guidelines ONLY and are by no means comprehensive. Installation should be performed by a professional plumber.
EZ-FLO International Inc. bears no responsibility for the improper installation or misuse of this product. These are only general recommendations.
Estas son guías de instalación SOLAMENTE y por ningún motivo son exhaustivas. La instalación debe ser realizada por un plomero profesional.
EZ-FLO International, Inc. no se responsabiliza por la instalación inadecuada o mal uso de este producto. Estas son solo recomendaciones generales.
© 2016 EZ-FLO INTERNATIONAL, INC.
2750 E. Mission Blvd. - Ontario, California, USA 91761
Dual Control Lavatory Faucet-Less-Pop-Up
Grifería para Lavamanos - Doble Manija
Incluye contra/desagüe
Limited
LIFETIME WARRANTY
Garantía de por vida limitada
Prestige
10093LF/10025LF
1.
2.
3.
4.
5.
6.
7.
8.
Index Button-Cold/Hot/Botón
Indice - Fría/Caliente
Metal Handle/Manija Metálica
Mounting Hardware/Piezas de
Montaje
Trim Cap/Moldura Tapón
1
2
3
4
5
6
7
8
Seat & Spring Set *2 / Juego de
Asiento y Resorte
Aerator/Aerador
3.
4.
Locking Nut/Tuerca de bloqueo
Ball Valve Assembly/Componentes
de Válvula de Bola
3
cross-head
screwdriver
desarmador de
estrella
pipe joint tape
cinta adhesiva
para tubería
10" groove
joint pliers
pinzas de junta
ranurada 10”
clear silicone latex caulk
sellador silicona-latex
transparente
sponge or rag
esponja o trapo
adjustable wrench
llave inglesa
Tools and supplies you will need the following to install your new faucet
Herramientas y provisiones que necesitara para instalar su nuevo grifo
utility knife
cuchillo para uso general
spanner
llave (23 mm)
basin wrench
llave de lavabo
supply
de la fuente
tube cutter
cortador de tubos
pipe wrench
llave de pipa
hacksaw
Sierra para metales
hex wrench(s)
llave hexagonal de
Before You Begin:
Turn off water supply
Remove old faucet.
Close drain to avoid losing
small parts.
Cierre el desagüe para evitar
perder piezas pequeñas.
Installation
Instalación
Antes de Comenzar:
Cierre el suministro de agua
Quite el grifo viejo.
4
Apply pipe tape onto the threads of the handle
valve body inlet port. Connect supply tube and
tighten with lock nut / Aplique cinta para tubería
a las roscas del puerto de entrada de el cuerpo de
la válvula de las manija.
Position faucet. Apply clear silicone latex
caulk to base plate / Fije la placa base.
Coloque el grifo. Aplique sellador de
silicona-latex transparente a la placa base.
Apply pipe tape onto threads of the water supply.
Tighten the hose onto water supply / Aplique cinta
para tubería a las roscas del suministro de agua.
Apriete la manguera al suministro de agua.
Troubleshooting Guide
Minor problems often can be fixed without a plumber. Before doing any work on the faucet, shut off water supply and
close stopper or drain to avoid losing small parts.
noituloSesuaCmelborP
Leak from spout Damaged or dirty seals Disassemble faucet, remove cartridge. Clean or replace
cartridge if necessary. Reassembel.
.
Leak from under handle Damaged cartridge Remove handle. Replace cartridge.
Uneven water spray Clogged aerator Remove aerator. Clean or replace aerator if necessary.
Leak from around aerator Bad aerator seal Remove aerator. Check to see that seal is flat and undamaged.
Replace aerator if necessary.
Water drains slowly or not at all Clogged drain Remove stopper. Remove visible debris.
If still clogged, remove and clean trap. Reassemble.
1
2
Slide large washer onto threaded rods and make
sure open slots are around copper tubes. Line up
faucet with edge of sink. Tighten nuts / Deslice la
arandela grande en las varillas roscadas y
asegúrese que las ranuras estén alrededor de los
tubos de cobre. Alinee el grifo con la orilla del
lavabo. Apriete las tuercas.
-
1
-
2
EZ-FLO 10025LF Installation guide
- Category
- Sanitary ware
- Type
- Installation guide
EZ-FLO 10025LF is a dual control lavatory faucet designed for easy installation and long-lasting use. It features metal handles with hot and cold indices, a locking nut for secure mounting, and a spout with an aerator for a steady water flow. The faucet is backed by a limited lifetime warranty for added peace of mind.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- español: EZ-FLO 10025LF Guía de instalación
Related papers
-
EZ-FLO 10305 Installation guide
-
-
-
-
-
-
-
-
-
Other documents
-
JAG PLUMBING PRODUCTS 18-567 18-566 Installation guide
-
Delta 643-KS-PR-DST Installation guide
-
Delta 761-SS-DST Installation guide
-
Allen + Roth 72-BVF11-BB-AR Installation guide
-
-
-
Gerber D304644BN User manual
-
Danze D303658 Installation guide
-
Project Source H90K-51D-PS-BN Installation guide
-
Danze D304119 Installation guide
