Component port
If your television set does not have an (available) HDMI connection, you can connect
the M740 to your TV using a component cable. In this case, the picture quality will be
good, but not perfect, as this type of connection uses an analog transmission path.
For an immaculate picture that is guaranteed to give you goosebumps, we recommend
using the HDMI 1.3 port.
Composite video – if you have to…
In the event that you cannot use any of the connections listed above on your TV set,
your last choice is the composite video output, which provides you with an analog, un-
modulated video signal. If at all possible, use one of the connections listed above to
enjoy the brilliance and other advantages of a high-denition TV picture.
Coaxial S/PDIF audio output
The digital coaxial audio output gives you (as the name implies) a digital, interference-
free audio connection to your hi- amplier/AV receiver etc. via a cinch (RCA) cable. The
matching mating socket on your amplier should likewise be orange. Before connecting
your Media Player to your amplier, please make sure that the volume on your amplier
is at a reasonable setting. Your eardrums and your speakers will thank you!
Optical S/PDIF audio output (TOSLINK)
The optical S/PDIF audio output provides a digital audio signal for transmission via a -
bre optic cable (TOSLINK). Many ampliers, TV sets and AV receivers have a connection
of this type. You can obtain a corresponding cable from electronics dealers.
Stereo audio output
As the composite video output provides an analog signal, these two cinch (RCA) jacks
provide an analog stereo audio signal. If you have a surround sound system, you should
select one of the digital connections listed above.
Network
Use this port if you would like to integrate the NOXON into your network via a
network cable. To distinguish it from the wireless or WLAN connection, it is frequently
referred to as a LAN or bre port. The port supports data rates of 10 and 100 Mbps.
If you use this method to connect the M740 to your network, use a standard network
cable with RJ45 connectors.
An LED (light-emitting diode) at this jack lights up steady or ickers in green to indicate
that the connection to the network has been established. If the diode does not light up
after you connect the cable, check both cable ends to make sure that the connectors are
inserted properly. When in doubt, use another cable.
Alternatively, you can connect the NOXON M740 wirelessly to your existing WLAN (wire-
less network) using the optional NOXON WLAN stick.