6
plugged in. Set the color control wheel to 4. When the heat-up period is complete the red light
will go off, the “Ready” light will come on and the beeper will briefly sound to remind you the
grid is up to temperature and ready for you to begin baking. When the green light comes on the
heaters are deactivated until the grids cool slightly below the baking temperature.
Keep hands away from the hot stainless cover and grid surfaces. Touch only the plastic parts
and handle provided.
SELECT THE TASTE/TEXTURE – WHICH IS JUST RIGHT FOR YOU
The versatile Quad
®
Baking System, unique to the WafflePro
®
, lets you control the baking
condition best suited to your taste and allows you to vary and modify the taste, texture and
aroma of the waffles any time you wish. By adjusting the batter you can further widen the flavors
and textures available. You can find the perfect combination for each recipe and for any of your
favorite toppings. Caution - Do not rely on the age-old notion that the waffle is done when the
waffle maker stops steaming. Because of the unique Quad
®
Baking System, the waffle may be
ready to serve while the WafflePro
®
is still steaming. Learn to rely on the green light and beeper
and vary the settings to your taste.
MAKING WAFFLES WITH CRISP EXTERIOR/MOIST INTERIOR
Waffles made with the Crisp Exterior/Moist Interior setting will retain more of the freshly–baked
aroma and flavor. The degree of exterior crispness will depend on the recipe and the color
control setting.
1. Depress the upper portion of the black circular rocker switch marked “Crisp Exterior/Moist
Interior.” Set the color control to 4 for the first waffle.
2. Pour or ladle about 1⁄2 cup of batter from a ladle or pitcher in the middle of the lower waffle
grid. A thicker batter, thin enough to just pour slowly works best. Avoid putting too much batter
on grid as that will cause an overflow and increase clean up time. Too little batter will not fill the
grid and heating will be uneven.
3. Close the lid immediately after adding batter so as to spread out the batter uniformly. Press
down lightly on the lid handle for several seconds in order to help level the batter. A special
hinge at the rear of lid adjusts automatically to ensure a uniform thickness of the waffle.
4. The red light will come on indicating the waffle is baking. This means the heater is powered to
continue the cooking process.
5. When the waffle is ready, the green light comes on, the red light goes off and the beeper
sounds briefly.
6. Lift the lid slightly and inspect the waffle color. If necessary, close the lid and continue heating
a little longer until desired color is obtained. On the next baking cycle adjust the color control
wheel as necessary to obtain a better setting. Movement to a higher number will darken the
waffle. Commonly the necessary adjustment is less than one whole number.
7. When the waffle is done, remove it by lifting one edge with a heat-resistant plastic fork or
spatula. (If you use a metal fork, use care not to contact grid surfaces as that might scratch
the non-stick surface and decrease its effectiveness.)
8. After removal of waffle, the WafflePro
®
can be immediately refilled with batter or it can be
closed until you are ready to bake again. If you do not start another waffle immediately the
green light will stay on until the grids cool slightly, then the red light will come on briefly
indicating the grids are being reheated to maintain readiness for the next use. When the
green light comes on again the next waffle can be poured and baked.