EN–4 instructions
EN
To replace the battery:
1. Locate the circular battery cover on the back of the foot pod.
2. Twist the cover counter-clockwise
until it is loose enough to remove.
3. Remove the cover and the battery.
4. Place the new battery into the cover with
the positive side facing the inside of the
cover.
5. Replace cover by aligning the dots and
rotating clockwise.
Technical Specications
Physical size: L × W × H: 35 mm × 25 mm × 7.5 mm
(excluding clip)
Weight: 10 g (including battery)
Water Resistance: 10 m
Transmission range:
Minimum 3 m (9.8 ft.)
Speed and distance accuracy: Uncalibrated 95%, calibrated
98%
Battery: User‑replaceable CR2032 (3 volts) Perchlorate
Material – special handling may apply. See www.dtsc
.ca.gov/hazardouswaste/perchlorate.
Battery life: 400 hours run time
Operating temperature: From ‑10°C to 60°C (From 14°F
to 140°F)
Sensor Accuracy Range: From 0°C to 40°C (From 32°F to
104°F)
Radio frequency/protocol: 2.4 GHz ANT
™
System Compatibility: ANT+
™
Limited Warranty
Garmin’s standard limited warranty applies to this accessory.
For more information, see the Important Safety and Product
Information in the Garmin product box.
Unlock
Lock