ROD 2
ROD 1
CONNECTOR
BRACKET
Step 1:
Assemble two sections of rod together with connector.
ROD ASSEMBLY
BRACKET ASSEMBLY
Step 2:
Measure opening of shower or tub enclosure and cut equal amount off each end of rod to match size of opening. Install rod
into brackets (sold separately) as per bracket installation instructions.
SR-72
INSTALLATION INSTRUCTIONS
No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.
-
1
Allied Brass SR-72-ORB Installation guide
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI