Necvox FD5869 Operating Instructions Manual

Brand: Necvox

Model: FD5869

Category: Motorcycle Accessories

Type: Operating Instructions Manual

Operating Instructions

7 inch Wide Screen Color Monitor

5.8 inch Wide Screen Color Monitor

5 inch Wide Screen Color Monitor

OT01003216-20020218

Important Notice

It is unlawful in most jurisdictions for a person to

drive a motor vehicle which is equipped with

a television viewer or screen that is located

in the motor vehicle at any point forward of

the back of the driver's seat, or that is visible

directly or indirectly, to the driver while op-

erating the vehicle.

CAUTION

1. Do not operate the monitor at temperatures below 32°F (0°C) or above 104°F (40°C).

2. Keep the monitor clean and dry.

3. Always seek qualified personnel to perform repairs. Never attempt your own repairs.

4. Do not drop the monitor or expose to strong impacts.

5. Do not expose to direct sunlight for extended periods of time.

2. Firmly attach dash mount on a flat surface and adjust viewing

angle of monitor by tightening the fastener at the side.

1. Slide monitor onto dash mount S2 and then tighten using

fastener.(Optional)

Installation Guide

1 To install the monitor into the seat head cushion you must ensure

that the monitor connecting cable assembly has already pull through

via the supporting pipe.

2 Before connecting the monitor, pull the connecting cable assembly

through the headrest shroud as shown in diagram 2.

3 Place headrest shroud into the opening and secure it with correct

fasteners.

Note : Installing Method of main cable assembly

1. Reeve the main cable assembly through (or beside)

the head rest support tube.

2. Secure and protect the cable assembly from damage

when the head rest is adjusted.

Installation Guide (Only for 5",5.8")

4 Connect the connecting cable assembly to the monitor.

5 Ensure that there is no

foreign material is trapped

inside theenclosure before

pushing themonitor onto the

headrest shroud.Make sure

that the monitor issecurely

locked in place.

HEADREST SHROUD

MONITOR

TRIM RING SHROUD

Interconnect Cable

Assembly , Monitor

Red Wire : ACC

Black Wire : Ground

Blue Wire : 12 Vdc (1A)

Output

Interconnection

Box AD-6865

Video Out

Video source 2

(Input)

Yellow Wire : Battery (+)

Wiring System :

Electrical Connections (General)

Video source 1

(Input)

Brown wire : Safety connection

(Hand - break switch)

In - Car Audio Equipment

Yellow wire : Battery (+)

Red wire : ACC

Black wire : Ground

Wiring System :

TV Tuner

(Stereo)

Electrical Connections

(System Upgrade)

FM Modulator

Antenna , AM/FM

88.7 MHZ

89.1 MHZ

TV Antenna

Diversity

MODE

ON / OFF and Mode

Selection

Infra-Red Remote Controller

Receiver

MODE

DOWN

Positive and Negative Adjustment

Activation of Menu Indicator

Positive and Negative Adjustment

TINT

FORMAT

RESET

DIMMER

BRIGHT

FORMAT Selection

TINT Adjustment

Brightness Adjustment

DIMMER ON/OFF

COLOR

On Screen Display (OSD) Indicator

Color Adjustment

Reset to Original Condition

Basic Operation (Monitor)

Press Menu Key

Using Menu Function Key :

Press Menu key until OSD indicator

at the correct function mode

COLOR

BRIGHT

TINT

MODE

OSD will appear on screen

COLOR

BRIGHT

FORMAT

RESET

DIMMER

FORMAT

RESET

DIMMER

TINT

MODE

User Guide - Remote Controller:

Menu (Activation of OSD and

Function Selection)

Mode Selection

Down Adjustment

Up Adjustment

POWER ON / OFF

4 5 6

MEMORY

CH/DISC/SET

POWER

1 2 3

MODE

4 5 6

MEMORY

CH/DISC/SET

POWER

1 2 3

MODE

MODE Key

Note:

Press Up & Down key (CH/DISK/SET)

to select system (NTSC PAL)

MODE

AV2 : NTSC

Press Mode key to select the

Press or to desire setting

desired video source input

(input 1 or input 2)

AV1 : NTSC

MODE

Key

Press to the desire setting

MODE

COLOR

Press to the desire setting

MODE

4 5 6

MEMORY

CH/DISC/SET

POWER

1 2 3

MODE

4 5 6

MEMORY

CH/DISC/SET

POWER

1 2 3

MODE

4 5 6

MEMORY

CH/DISC/SET

POWER

1 2 3

MODE

VOL 32

Åã¥Üµøµ¡

VOL

AV1 : PAL

AV2 : PAL

FULL: 16:9 picture is fully displayed on screen.

ZOOM: Picture stretched vertically and horizontally.

NORMAL: When 4:3 picture is played on a wide screen, black bands

appear on both side of the picture.

Display Mode :

1. Press MENU to indicate OSD

2. Select FORMAT

3. PRESS to switch the screen size

ZOOM

FULL

NORMAL

OSD will appear on screen

1. Use a small coin to ply open

battery holder from compartment.

2. Remove old battery and put in a

new one with positive sign " + "

facing upward.

3. Push compartment into position.

Precaution :

1. Dispose off used battery properly.

2. Do not misuse battery by short - circuiting the " + " and " - "

terminal or put it into fire.

3. Remove used battery from compartment to prevent leakage from

damaged battery.

4. To avoid accident , do prevent children from playing with the

battery.

To avoid electrical shock , do not open the enclosure . High voltage is

present . No user serviceable parts inside the enclosure .

Do not use any chemical solvent , cleaning agent or corrosive detergent

to clean away dirt on the surface of the screen . To clean off dirt or finger

print , we recommend the use of a soft damp lens cleaning cloth .

Should there be requirement to replace blown fuse , do remember to

disconnect all power supply and switched off the unit before replacing it

with a new one . Use only correct rating fuse to avoid damaging the unit .

Maintenance :

Replacement of battery

Remote Controller :

remote controller

battery holder

battery

Remote Controller

Main Cable

Instruction Manual

Power Cable

Headrest Shroud (Only For 5", 5.8")

Trim Ring Shroud (Only For 5", 5.8")

Interconnection Box , AD- 6865

Dash Mount , S2 (Optional - for 5",5.8")

Item Description

Precautions :

1. This unit should be install by qualified technicians

or service personnel.

2. This product is designed to operate with a 12 volt,

negative ground battery system.

3. Disconnect the ground wire from the battery terminal before connecting

the electrical system.

4. Refer to the electrical connection diagram to avoid wrong connection of

the electrical system. Always use authorized service center for service

assistance.

5. Use proper insulation material to prevent short - circuiting of the supply

system.

6. Tighten all loose wires after installation.

7. Refer to this operating instruction for system upgrade and operation.

Accessories Supplied :

Item

Quantity

Necvox FD5869 Operating Instructions Manual

Brand: Necvox

Model: FD5869

Category: Motorcycle Accessories

Type: Operating Instructions Manual

Download PDF

report

Necvox FD5869 Operating Instructions Manual

Necvox FD5869 Operating Instructions Manual

Other documents