Toro Heat Shield Kit, Backhoe for Compact Utility Loader Installation guide

Form No. 3357-665 Rev A

Heat Shield Kit

For Backhoe for Compact Utility Loaders

Model No. 112-2532

Installation Instructions

Loose Parts

Description Quantity

Frame 1

Vinyl cover

Bolt (1/4 x 1-1/4 inches)

Installing the Heat Shield

1. Place the vinyl co v er on the underside of the

frame and secure it around the rods with the

hook and loop fasteners ( Figure 1 ).

G005394

Figure 1

1. Vinyl cover 4. Seat stand

2. Frame rods (not covered by

vinyl cover)

5. Operator platform

3. Bolts and nuts (not shown)

at the rear of the platform

2. R emo v e the seat and seat brac k et from the seat

stand.

3. R emo v e the 2 bolts and n uts from the rear of

the operator platfor m. Discard the bolts but

sa v e the n uts .

4. Place the heat shield do wn o v er the seat stand

( Figure 1 ).

5. Secure the tabs at the base of the heat shield

to the operator platfor m, using 2 bolts (1/4 x

1-1/4 inc hes) from the kit and the 2 n uts that

y ou remo v ed previously ( Figure 1 ).

6. Install the seat.

8111 Lyndale Avenue South

Bloomington, MN 55420

Printed in the USA.