Precision Plumbing Products MM-500PIMB Installation guide

Hello! I'm your assistant and I've reviewed the installation instructions for the Precision Plumbing Products Ice Maker Box models MM-500MIMB and MM-500PIMB. The document provides step-by-step guidance on how to install these ice maker boxes, and gives precaution about heat near the plastic box. I'm ready to answer any questions you might have about the installation process.
What should I do before securing box?

How to secure the box?

What is the next step after box secured?

How to install face plate?

Precision Plumbing Products

“Specify with Condence - Install with Pride”

FLUID HAMMER ARRESTORS Ice Maker Box Installation

www.pppinc.net

METAL OR PLASTIC ICE MAKER BOX INSTALLATION

INSTALLATION:

1) Position box between studs to desired height.

2) Secure box to a backing board or to the front of studs. The front of the box should be ush with wall

material.

3) Connect the cold water supply to the valve.

4) Install face plate by pushing plate into box until plate is ush against the wall material.

USE CAUTION WHEN APPLYING

HEAT NEAR THE PLASTIC BOX.

Plastic Ice Maker Box

MM-500PIMB

Metal Ice Maker Box

MM-500MIMB

Precision Plumbing Products

Division of JL Industries, Inc.

802 SE 199th Avenue

Portland, Oregon 97233

T (503) 256-4010

F (503) 253-8165

www.pppinc.net

Rev 11/13

LEAD FREE