1
CORDLESS CLIPPER
CORDLESS CLIPPER
INSTRUCTIONS
2
CORDLESS CLIPPER
CONTENTS
GENERAL USER INFORMATION Page 3
IMPORTANT SAFEGUARDS Page 4
OPERATING INSTRUCTIONS Page 8
CARE AND CLEANING Page 12
WIRING Page 12
DISPOSAL Page 13
GUARANTEE Page 14
DECLARATION OF CONFORMITY Page 15
Please read all instructions carefully to familiarise yourself
with your new clipper before using.
Save these instructions for further reference.
For any further assistance or information call Customer Services on
T: 01227 740066
or visit
W: www.wahl.co.uk
E: customer[email protected]
3
CORDLESS CLIPPER
GENERAL USER INFORMATION
Information about using the operation manual
►Before using the appliance for the rst time,
you must read and understand the operation
manual completely.
►Consider the operation manual as part of the
product and store it in a safe and accessible
place.
►Include this operation manual if passing the
appliance on to a third party.
►In the case of conicts with national safety
specications or instructions, the national
requirements must be followed.
Explanation of symbols and notes
DANGER
Danger of electric shock which may result in serious physical injury or death.
DANGER
Danger of explosion which may result in serious physical injury or death.
WARNING
Warning of possible physical injury or a health risk.
CAUTION
Information about danger of material damage.
Note with useful information and tips.
Action to be taken by owner.
Carry out these actions in the sequence described.
List
1.
·
4
CORDLESS CLIPPER
Please retain this leaet for future reference.
READ ALL INSTRUCTIONS BEFORE USING.
IMPORTANT SAFEGUARDS
When using this electrical appliance, especially when
children are present, basic safety precautions should
always be observed including the following.
Requirements
►Read the instruction manual in full to
familiarise yourself with the product before the
rst use.
►This appliance can be used by children
from aged 14 years and above and
persons with reduced physical, sensory or
mental capabilities, or lack of experience
and knowledge, if they have been given
supervision or instruction concerning use of
the appliance in a safe way and understand
the hazards involved. Children shall not
play with the appliance. Cleaning and user
maintenance shall not be made by children
without supervision.
►Use this appliance only for its intended
purpose.
5
CORDLESS CLIPPER
Hazards
Danger! Electric shock due to damage to
appliance
►Do not operate the appliance with a broken
cord, plug or charger, or if the appliance
malfunctions, or is dropped or damaged in
anyway.
►Any servicing or repair must be performed by
an authorised service representative.
►The use of attachments that are not supplied
by the manufacturer may cause re, electric
shock or injury and damage to the appliance.
Danger! Electric shock due to penetration
of liquid.
►To protect against risk of electrical shock,
never immerse the unit or let it come into
contact with water or any other liquids. Do not
use the unit with wet hands. If the appliance
should become wet, damp or fall in water,
remove plug from mains socket immediately.
Do not put your hands in the water. Do not
take into bathroom.
Danger of explosion
►Never use the appliance where aerosol (spray)
products are being used or where oxygen is
released.
6
CORDLESS CLIPPER
►Exhausted batteries/ rechargeable batteries
should not be disposed of in the household
waste. Dispose of them in a completely
discharged state in accordance with local legal
regulations. Do not throw into re where heat
could cause them to rupture.
Warning! Injuries due to incorrect handling
►Switch off the appliance and unplug from outlet
when not in use, before putting on or taking
off attachments and also before cleaning the
appliance.
►Never use your appliance without paying
attention! Except when charging always
unplug this appliance from the electricity outlet
immediately after using.
Caution! Danger of product damage
►
Do not wrap the cord around the appliance / charger.
►
Do not use outdoors or in damp areas.
►
Never carry the unit by its power cord.
►
Do not drop or insert any object into any opening.
7
CORDLESS CLIPPER
21
4
3
5
6
7
0,5 – 1,0 mm
a
b
b
a
b
a
8
CORDLESS CLIPPER
OPERATING INSTRUCTIONS
CHARGING PRECAUTIONS
CHARGING THE BATTERY
Before the equipment is used for the rst time, it should be
charged 3-5 hours. Plug power cord directly into unit. Be sure
clipper is switched OFF when charging. During charging, the
charge indicator is illuminated. The charge indicator will begin
to blink when almost fully charged and may shut o when fully
charged.
USING RECHARGEABLE CORD/CORDLESS CLIPPERS
This unit may be used without a cord when
fully charged. If battery power is low, a
power cord can attach directly to the unit for
continued use as a corded unit.
• Plug power cord into an outlet at the
correct voltage.
• Plug power cord directly into unit. Be sure
clipper is switched OFF when charging.
• FOR CORDED OPERATION, connect to receptacle on the
bottom of the unit. If your battery is completely run down,
allow the unit to charge for 1 minute (switched OFF) before
using as a corded unit.
• If the cord is left attached to the unit when not in use, the
cord will automatically charge the unit when left in the OFF
position.
9
CORDLESS CLIPPER
TROUBLESHOOTING
If your cordless clipper does not seem to be operating or
charging properly, please check the following: Check the
outlet’s current by plugging another appliance (one you know is
in proper working condition) into the outlet.
Make sure the unit is not connected to a power source that
turns itself o when lights are turned o.
Make sure the clipper and charging contacts are clean and free
of hair or other contaminants.
Verify that the blade assembly moves freely and is mounted
properly.
The battery is a non-consumer replaceable battery. Return to
Wahl for replacement if and when necessary.
ATTACHMENTS
To attach the combs, hold comb with teeth up and snap it rmly
to the bottom of the clipper blade. (Fig. 3) For uniform cutting,
allow the clipper to cut its way through the hair. Do not force it
through at a faster rate.
CHANGING THE BLADE SET
(5 star models)
Warning! Injuries and material damage due to incorrect
handling.
f Switch the appliance off and disconnect before changing
the blade set.
1.Switch the appliance off using the on/off switch (Fig. 1b) and
disconnect.
2.Undo the screws on the blade set; remove the bottom blade and the
top blade (Fig. 5).
When assembling, the bottom blade and the top blade should be
aligned as follows:
f Set the adjustment lever to the shortest cutting length (Fig. 2
a
).
10
CORDLESS CLIPPER
3.Place the top blade on the plastic cam (Fig. 6).
4.Position bottom blade and reinsert the two screws.
5.Before tightening the screws, align the bottom blade (Fig. 7).
Align the bottom blade so that there is a gap of 0.5 mm to 1.0 mm
between the front edge of the bottom blade and the front edge of
the top blade (Fig. 7)
6.Tighten screws (Fig. 5).
CHANGING THE BLADE SET(Standard models)
1.Switch the appliance o using the on/o switch (Fig. 1b) and
disconnect.
2.Undo the screws on the blade set; remove bottom blade and top
blade (Fig. 5) - a Torx T20 screwdriver will be required (available
from most good DIY stores)
3.The blade can now be removed for cleaning or replacement
4.To re-assemble, place the top blade on the plastic cam (Fig. 6)
5.Position bottom blade and reinsert the two screws
6.Tighten screws (Fig. 5) - no blade alignment is required, once the
Torx screws are tightened the blade will be automatically aligned
in the correct position
Warning! Injuries due to incorrect handling.
Do not use the appliance if the teeth are damaged or missing
from the blade or if the blades are misaligned as injury may
occur.
TAPER LEVER
Some clippers are equipped with an adjustable taper lever that
changes the closeness of your cut. When the lever is in the
uppermost position, the blades will give the closest cut (Fig. 2a)
Pushing the lever downward gradually increases the cutting length
(Fig. 2b)
11
CORDLESS CLIPPER
BATTERY OPERATION
Switch on the equipment using the on/o switch and, after use,
switch it o again. When the battery is fully charged, the equipment
can be used for up to 90 minutes continuous run time. Two hours to
reach a full charge with a discharged battery.
Recommendation: the batteries should only be recharged when
the performance of the equipment has deteriorated noticeably.
LITHIUM-ION BATTERY REPLACEMENT
This product uses a lithium-ion battery. For proper disposal of this
appliance, please refer to disposal section on page 12.For battery
replacement send the entire, intact clipper unit to Wahl (UK) Limited.
Do not attempt to remove the battery. Lithium-Ion batteries can
explode, catch re, and/or cause burns if disassembled, damaged,
or exposed to water or high temperatures.
If you choose not to replace the battery, the entire, intact clipper
must be disposed. Do not attempt to remove the battery for
disposal. Lithium-Ion batteries may be subject to local disposal
regulations.
12
CORDLESS CLIPPER
CARE AND CLEANING
• Always disconnect the appliance before any cleaning operation.
• To clean the unit, use either a clean dry or dampened cloth. Do not
use abrasive cleaning agents or scrub pads. Do not use alcohol or
solvents.
• To remove hair from between the blades, use the cleaning brush
provided.
• The blades must be re-aligned if they have been removed for
cleaning or replacement on the 5 Star models(Fig. 7). No re-
alignment is required on the standard models.
• After each use, blades should be cleaned and oiled. Put a small
drop of Wahl Clipper Oil between the blades while the trimmer is
running. Wipe o excess oil so it does not run into the motor. (Fig.4)
• Do not store the appliance in a wet or moist environment.
• Never immerse the appliance in water or any other liquid.
DO NOT USE bleach, benzene or thinner to clean the unit.
WIRING
THIS PRODUCT MUST ONLY BE USED WITH THE CABLE
SUPPLIED. SHOULD A REPLACEMENT BE REQUIRED
CONTACT WAHL CUSTOMER SERVICES.
13
CORDLESS CLIPPER
DISPOSAL
Handle with care! Environmental damage in the case of
incorrect disposal.
Correct disposal will ensure environmental protection and prevent any
potentially harmful impacts on people and the environment.
Adhere to the relevant legal requirements when disposing of the appliance.
Information on the disposal of electrical and electronic appliances in the
European Community:
Within the European Community, national regulations are
specied for the disposal of electrical appliances, based on EU
Waste Electrical and Electronic Equipment Directive 2002/96/EC
(WEEE). In accordance with this, the appliance can no longer be
disposed of with the local or domestic waste.
The appliance will be accepted free of charge by local collection
points or recycling centres.
14
CORDLESS CLIPPER
GUARANTEE
This product is guaranteed against defects in material and workmanship
for a period of 1 year from the date of original purchase or receipt as a
gift.
Should this product become defective during the guarantee period,
return it to the store of purchase together with your proof of purchase for
repair or replacement.
Alternatively within the guarantee period you can return the product to
Wahl (UK) Ltd who will repair any such defect or elect to replace the
product or any part of it, without charge, provided that there is proof
of purchase. Should a replacement be oered this will not extend the
original guarantee period.
The guarantee becomes invalid in the case of misuse, alteration or
repair by unauthorised persons.
This guarantee does not include blades, cables, shaver heads, foils and
cutters etc. which are consumable parts.
This guarantee in no way aects your rights under statutory law in the
United Kingdom.
15
CORDLESS CLIPPER
16
CORDLESS CLIPPER
WAHL (UK) LTD
STERLING HOUSE
CLIPPER CLOSE
RAMSGATE, KENT
CT12 5GG
CUSTOMER SERVICES T: 01227 740066
www.wahl.co.uk
Form No. ZB399A
Rev.3 06-19
/
