Page is loading ...
1
Safety first!
Always remove the mains plug from the
socket when you have:
1) Finished using the blender, before you clean
the blender.
2) Before you put on or remove the jar.
3) If any fault occurs.
To protect against risk of electrical shock,
do not put the blender base containing motor
and cord in water or other liquid.
Do not operate any appliance with damaged
cord or plug, or after the appliance malfunctions,
or is dropped or damaged in any manner.
If the supply cord is damaged, it must be replaced
by a qualified person to avoid a hazard.
The use of attachments, including canning jars,
not recommended or sold by the manufacturer
may cause fire, electric shock or injury.
Children should never be allowed to use
the blender.
Never leave the appliance plugged in when
there are young children around.
• The Blender has been designed for household
use only.
This unit is not suitable for commercial use.
• Avoid contact with moving parts. Wait until the
blades have stopped rotating before you remove
the jar.
• Do not put your hands or any utensils such as forks
or spoons into the jar while the blades are rotating.
• Always operate the blender with lid in place.
• Do not let cord hang over edge of table or counter,
or touch hot surfaces, including the stove.
• When filling the blender jar, do not exceed the
Max mark indicated on the jar (52 oz, or 1500ml)
• Do not use outdoors.
• Repairs must only be carried out by qualified service
engineers.
Never use the blender if it is not working properly,
or it has been dropped or damaged.
• Blades are sharp. Handle carefully.
Do not use hot liquid in your blender as this may affect the
security of the lid when in use and in some circumstances
could allow the contents to be ejected.
Hitachi BLN1 E UK.qxd 03/01/2006 14:10 Page 1
Connect the plug to the mains socket.
Add ingredients to be processed, and place
lid on blender jar. Be sure lid is fully seated.
Switch on by turning the dial (see next fig.)
to either of the position. (P 0 I II setting)
0 = OFF
l = LOW speed
ll = HIGH speed
P = PULSE blending (The dial returns to '0'
setting as soon as you release it)
The 'P' pulse setting is ideal for crushing ice.
How to use your Liquid Blender:
Blade assembly must be securely tightened to the blender jar before placing any food or liquid inside the Jar.
If necessary, you can add extra ingredients through
the refill hole and place the filler cap back in the
lid before activating blender.
When the blending is finished, switch the
dial back to '0' setting.
Do not exceed the Maximum level.
Always hold the lid down when starting to blend.
Do not operate the blender longer than 2 minutes.
After each 2 minute session the blender must be
allowed to cool down for at least 10 minutes.
A small quantity of water must be added to the ice
when crushing ice alone. Ice will not crush without
some form of liquid.
Do not use hot liquid in your blender as this may
affect the security of the lid when in use and in
some circumstances could allow the contents to be
ejected.
WARNING
Hitachi BLN1 E UK.qxd 03/01/2006 14:10 Page 2
�
/