Electric Potato Peeler 8118 Instructions
OPERATING INSTRUCTIONS FOR POTATO PEELING
• Push the blade disk onto its axis. Take care as the blade is
sharp.
• Check that all parts are correctly positioned and add
enough potatoes to cover the blade disk.
• Water may be added if required – if so, add no more than
200ml.
• Close the lid ensuring the lid is on the correct way. The T
shaped part on the underside of the lid must align with the
Upper cut out switch. Push the cover clips firmly down into
place.
• Switch the power ON and the Potato Peeler will begin to
work. Please be aware that the appliance will vibrate during
use but the rubber feet keep the appliance from moving.
• The Potato Peeler should take about 2 minutes to peel all
the potatoes. However, due to each potato being a different
size and shape, this may vary.
• Check progress regularly.
• Once potatoes are peeled, or after 4 minutes, turn the
switch to OFF on the Potato Peeler, turn OFF at the mains
and unplug, before removing the lid and carefully taking the
potatoes out. Do not run the Potato Peeler for more than 4
minutes at a time.
• Wash potatoes in fresh water before cooking and remove
any excess peeling with a small knife. N.B. the Potato Peeler
can not remove skin from recesses or irregular shapes.
OPERATING INSTRUCTIONS FOR SALAD SPINNING
• Push the salad spinner into place. The blade disk is not used.
• Close the lid and follow the instructions as above for
operation.
CLEANING
• Always switch OFF and unplug from the mains before
cleaning.
• Wash the bowl, lid, salad spinner and blade disk in hand
hot soapy water only.
• Never use abrasives to clean.
• Take care when cleaning the blade disk as parts are very
sharp.
• Not dishwasher safe.
PACKAGING
Dispose of the packaging at your local recycling centre.
Dispose of paper and carton separately from plastic bags at
your local recycling centre.
Dispose of the item at the end of its lifespan at your local
authorised household waste recycling centre.
Blade disk does not rotate Safety cut out switches not aligned. • Ensure the lower cut out switch is aligned
correctly from the base unit to the bowl.
• Ensure the upper cut out switch is aligned
correctly by checking the lid is on the correct
way round.
Unit does not switch on Fuse has failed. Check fuse and replace.
Potatoes not peeled fully • Irregularly shaped potatoes. • The blade disk can not peel into recesses or
irregular shapes. These must be finished by hand.
• Too many potatoes loaded. • Reduce the quantity of potatoes and try again.
TROUBLE SHOOTING
Problem Cause Solution