The Metra 99-2007 is a versatile car stereo installation kit that provides a range of mounting options for aftermarket radios in select Cadillac Escalade models from 2007 to 2010. It features an ISO mount radio provision with a pocket for single DIN radios, a double DIN radio provision, and a stacked ISO units provision for mounting two ISO units.
The Metra 99-2007 is a versatile car stereo installation kit that provides a range of mounting options for aftermarket radios in select Cadillac Escalade models from 2007 to 2010. It features an ISO mount radio provision with a pocket for single DIN radios, a double DIN radio provision, and a stacked ISO units provision for mounting two ISO units.
INSTALLATION INSTRUCTIONS FOR PART 99-2007
99-2007
APPLICATIONS
Cadillac Escalade
2007-2010
KIT FEATURES
• ISO Mount Radio Provision With Pocket
• Double DIN Radio Provision
• Stacked ISO Units Provision
A) Radio Housing • B) Radio Housing Trim Plate • C) Radio Housing Brackets • D) Pocket
• E) 4) #8 3/8” Screws
KIT COMPONENTS
S
S
S
A
Small Flat Blade Screwdriver/ Panel Removal Tool
• Phillips Screwdriver • Socket Set
1-800-221-0932
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
www.metraonline.com
D
E
TOOLS REQUIRED:
B
C
WIRING AND ANTENNA CONNECTIONS
(Sold Separately)
• 40-CR10 - 2002-up Chrysler/GM Antenna Adapter
• GMOS-LAN-05 - 2007-up GM LAN Digital Amp Interface
Dash Disassembly
-
Cadillac Escalade 2007-2010. . . . . . . . . . . . . . . . . .
. . . . . . . . 1
Kit Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Kit
Assembly
- ISO Mount Radio Provision with Pocket
. . . . . . . . . . . . . . . . . . . . . . .3
- Double DIN Radio Provision
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
- Stacked ISO Units Provision
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Final
Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
TABLE OF CONTENTS
99-2007
*Note:
Ref
er also to the instructions included with the aftermarket radio.
K
NOWLEDGE IS
P
OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
99-2007 DASH DISASSEMBLY
CADILLAC ESCALADE 2007-2010
A
B
C
D
1
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
Unclip and remove cup holder and
ashtray assembly. (
Figure A)
2
Unclip and remove the trim panel
above the glove box including the a/c
vent. (
Figure B)
3
Unclip and remove the entire panel
surrounding the radio including the a/c
vents.
(Figure C)
4
Remove (6) 9/32” screws to extract
radio from dash.
(Figure D)
5
Continue to kit assembly.
99-2007 KIT PREPARATION
CADILLAC ESCALADE 2007-2010
2
Cut and remove the shaded areas marked with an “S” only from the radio
housing.
(Figure A) Right side and top of Radio housing. (Figure B) Left side and top of
Radio housing.
NO
TE: Do NOT remove the tab marked with both “S” and “E”.
1
Continue to kit assembly.
A
S
S
S
B
S
S
S
99-2007 KIT ASSEMBLY
3
B
C
D
ISO MOUNT RADIO PROVISION WITH POCKET
2
Slide the pocket into the top of the
opening aligning the holes in the
radio housing brackets with the
bosses on the pocket and secure
using the provided (4) #8 3/8”
screws.
(Figure B)
3
Slide the ISO radio into the opening
below the pocket and secure the unit
to the kit using the screws supplied
with the radio.
(Figure C)
4
Snap the radio housing trim plate
onto the front of the radio housing.
(Figure D)
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.
Flip the radio housing brackets upside
down then snap them to the inside
edge of the radio housing.
(Figure A)
1
A
4
99-2007 KIT ASSEMBLY
B
C
A
DOUBLE DIN RADIO PROVISION
Slide the Double DIN radio into the
radio housing bracket assembly and
secure the unit using the screws sup-
plied with the radio.
(Figure B)
2
Snap the radio housing trim plate onto
the front of the radio housing.
(Figure C)
3
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.
Attach the radio housing brackets to
the inside edge of the radio housing.
(Figure A)
1
99-2007 KIT ASSEMBLY
5
B
C
STACKED ISO UNITS PROVISION
2
Slide the stacked ISO units into the
radio housing bracket assembly and
secure the unit using the screws sup-
plied with the units.
(Figure B)
3
Snap the radio housing trim plate
onto the front of the radio housing.
(Figure C)
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.
Attach the radio housing brackets to
the inside edge of the radio housing.
(Figure A)
1
A
99-2007 FINAL ASSEMBLY
FINAL ASSEMBLY
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
A
B
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adapter and making connections as shown. (Isolate and individ-
ually tape off the ends of any unused wires to prevent electrical short circuit.)
Re-connect the negative battery terminal and test the unit for proper operation.
Reassemble radio and dash assemblies in reverse order of disassembly.
1
2
3
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
METRA / EIA WIRING CODE
12V Ignition / Acc. . . . . . . . . . Red
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer . . . . . . . . . . . . . . . . . Orange / White
Right Front (+) . . . . . . . . . . . . Gray
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
1-800-221-0932
REV. 04/21/10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-2007
www.metraonline.com
individually tape off ends of any unused wires to prevent electrical short circuit.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
The Metra 99-2007 is a versatile car stereo installation kit that provides a range of mounting options for aftermarket radios in select Cadillac Escalade models from 2007 to 2010. It features an ISO mount radio provision with a pocket for single DIN radios, a double DIN radio provision, and a stacked ISO units provision for mounting two ISO units.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Metra Electronics 99-7423 User manual
-
Metra Electronics 99-8218 User manual
-
Metra Electronics 99-5807 User manual
-
Metra Electronics ACURA 95-7868B User manual
-
Metra Electronics Car Stereo System 99-7334 User manual
-
Metra Electronics 99-7581 User manual
-
Metra Electronics 99-6510 User manual
-
Metra Electronics 95-7322 User manual
-
Metra Electronics 99-6511 User manual
-
Metra Electronics 95-3305 User manual
