© Pro-Ject Audio Systems · VC-S 7” kit · Revision 2017.04.03
Dear music lover,
Thank you for purchasing a Pro-Ject Audio Systems record cleaning machine and its upgrade for 7”records.
This manual is an extension of the original instruction manual of the VC-S unit
specifications, safety procedures and using of VC-S, please see instruction manual for VC-S.
Pro-Ject VC-S 7” kit includes following items
1 Vacuum arm for 7” records* including short adhesive velvet strips
2 Clamp for 7” records
3
vinyl cleaning concentrate (100ml spare bottle for your convenience).
Setting up the unit with 7” kit
1. Remove original vacuum arm supplied with the VC-S unit and install vacuum arm for 7” records.
(New vacuum arm is longer and has shorter hole for suction).
Make sure that the VC-S 7” kit includes proper version of vacuum arm to match with your version of
VC-S: There are two versions of the flange for vacuum arm and each will require a
Synthettic (black) flange and Aluminium (silver) flange. Arms are not interchangeable. Information
about version of the arm is stated on packaging of the VC-S 7” kit.
2. Use supplied clamp for 7” records for fixing the record when using 7”kit. Original clamp doesn´t
work with longer 7” arm.
Service
Should you encounter a problem which the above information does not able to alleviate or identify, please
contact your dealer for assistance.
Guarantee repairs will only be affected if the unit is returned correctly packaged. For this reason we recommend
keeping the original packaging.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use and/or by transportation without the original packaging. Modification or change to any part
of the product by unauthorized persons will void the manufacturer’s warranty.
Pro-Ject Audio Systems is a Registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright
©
2017. All rights reserved.
The information was correct at the time of printing.
The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessar
process of technical development.