Inventum VST401W Owner's manual

Page is loading ...

• 3

1. veiligheidsvoorschriften pagina 4

2. montage instructies pagina 7

3. het gebruik van de ventilator pagina 8

4. reiniging & onderhoud pagina 8

algemene service- en garantievoorwaarden pagina 23

1. safety instructions page 9

2. assembly instructions page 11

3. using the fan page 12

4. cleaning and maintenance page 12

general terms and conditions of service and warranty page 24

1. Sicherheitshinweise Seite 13

2. Anweisungen für die Montage Seite 16

3. Verwendung des Ventilators Seite 17

4. Reinigung & Wartung Seite 17

Allgemeine Service- und Garantiebedingungen Seite 25

1. consignes de sécurité page 18

2. instructions de montage page 21

3. utilisation du ventilateur page 22

4. nettoyage et entretien page 22

conditions générales de garantie et de service après-vente page 26

Nederlands

English

Deutsch

Français

Page is loading ...

English

safety instructions

1

• Carefully and fully read the user manual prior to using the

appliance and carefully store the manual for future reference.

• Only use this appliance for the purposes described in the instruction.

• Caution: never insert ﬁngers or objects into the ventilation grid when

the appliance is switched on.

• Only connect the appliance to alternate current, with a mains

voltage that corresponds with the information provided on the

information plate of the appliance.

• Never bend the power cord sharply or allow it to run across hot parts.

• Fully unwind the cord to prevent it from overheating.

• Never place the appliance near appliances that give off heat, such

as ovens, gas cookers, hotplates, etc. Keep the appliance away from

walls or other objects that could catch ﬂame, such as curtains,

towels (cotton or paper, etc.).

• Always make sure the appliance is placed on an even, ﬂat surface.

• Only use the appliance indoors.

• Do not leave the appliance unsupervised if the appliance is

operational.

• If you want to move the appliance, make sure the appliance is

switched off.

• Do not use the appliance if the plug, cord or appliance are damaged,

or if the appliance no longer functions properly or if it is damaged in

any other way. If this is the case, consult the shop or our technical

service.

• If the cord of the appliance is damaged, it should be replaced by the

manufacturer, his customer service or a similarly qualiﬁed person in

order to prevent hazardous situations.

• Never replace the plug or cord yourself. Repairs to electrical

appliances should only be performed by skilled persons. Incorrect

repairs could cause considerable hazards for the user.

• Never use the appliance with parts that are not recommended or

supplied by the manufacturer.

• Do not pull the cord and/or appliance to remove the plug from the

wall socket. Never touch the appliance with wet or moist hands.

• Never connect the appliance to an external timer or a separate

remote control system, in order to prevent hazardous situations.

• Keep the appliance out of reach of children. Children do not see the

English • 9

dangers when handling electrical appliances. Therefore, never allow

children to work with electrical appliances without supervision. Keep

the appliance and cord out of reach of children younger than 8 years

of age.

• The appliance can be used by children of 8 years and older and

persons with a limited physical, sensory or mental capacity or

lack of experience or knowledge, provided they use the appliance

under supervision or have been instructed about its safe use and

understand the hazards involved.

• Children are not allowed to play with the appliance.

• The appliance may not be cleaned or maintained by children, unless

this is done under supervision.

• If the appliance is not being used or is being cleaned, fully switch off

the appliance by removing the plug from the socket.

• Extension cords may only be used if the mains voltage (see the

information plate) and capacity are identical to or higher than that of

the appliance. Always use an approved extension cord.

• If you decide not to use the appliance any more due to a defect, we

recommend cutting off the cord after removing the plug from the

wall socket. Take the appliance to the waste processing department

concerned of your municipality.

• Never submerge the appliance, cord or plug in water.

• This appliance is intended for household and similar use, such as:

- in staff kitchens, shops, ofﬁces and other

work environments;

- by guests of hotels, motels and other residential environments;

- in Bed&Breakfast type environments;

- farms.

• If the appliance is not used as intended, no compensation can be

claimed in case of defects or accidents and the warranty will be

invalidated.

• If you decide not to use the appliance any more due to a defect,

we recommend cutting off the cord after removing the plug

from the wall socket. Small household appliances do not belong

in the dustbin. Take the appliance to the waste processing

department concerned of your municipality.

10 • English

assembly instructions

2

Before using the fan for the ﬁrst time, please proceed as follows: carefully unpack the appliance and all components and remove all

packaging material and any promotional stickers. Keep the packaging (plastic bags and cardboard) out of the reach of children. After

unpacking the appliance, check it for external damage that may have occurred during transport.

Assemble the fan in accordance with the instructions.

In order to make the assembly process more easy, we recommend removing components [ a ] and [ b ] before you start.

1. Start by placing the footplate at the pedestal. Align the pedestal with the groove on the footplate and attach them to one another

with the hook bolt [ b ] .

2. Place the motor section on the pedestal and fasten it with screw [ a ].

3. Place the rear protective guard on the fan.

4. Fasten it by tightening the lock ring.

5. Insert the fan blade onto the fan. Test the fan blade by rotating it by hand. During rotation,

the blade should not create any friction with the lock ring. If it does, remove the fan and repeat all steps from the beginning.

6. Mount the fan blade with the fastening cap. Tighten the fastening cap by turning it to the left - counter-clockwise.

7. Place the front protective guard on the fan and use the clamps to attach it to the rear protective guard.

- Align the front protective guard with the rear protective guard using the positioning clamp [ c ] on the

bottom side in order to attach both parts to each other properly. Use the bolt and nut at the top of the guards to fasten the

guards to each other.

- Press the clamps [ d ] downwards in order to fasten the front and rear protective guards to each other.

4

5

6

7

1

2

3

Protective guard - front

Protective guard - rear

Fan blade

Lock ring

Fastening cap

Motor

Pedestal

Footplate

a

b

d

b

d

c

bolt and nut

English • 11

Place the fan on a ﬂat, stable surface. Clean the exterior of the fan using a slightly damp cloth and then wipe it with a dry cloth.

The fan is ready for use.

Place the fan on a ﬂat, stable surface. Insert the plug in a wall socket. Press the required position to switch on the fan. The position

switch has the following options:

0 = off

1 = slow

2 = medium

3 = fast

To switch off the fan, press [ 0 ].

Oscillation

This fan is able to oscillate (swerve to the left and right) for a better air displacement.

If you want to change the wind to an upward or downward direction, you can simply move the fan head upwards or downwards.

Adjusting the height of the pedestal

In order to adjust the height, loosen the pedestal adjustment nut and move the fan upwards or downwards. Properly hold on to the fan

when loosening the pedestal adjustment nut, so it cannot drop down unexpectedly. Re-tighten the pedestal adjustment nut when the

fan is at the required height.

using the fan

3

Push in the oscillation pen to allow the fan to

oscillate.

If you want to stop the oscillation, simply pull out

the pen.

oscillation pen

manual tilting

operation

3

2

1

0

Adjusting the height of the

pedestal

cleaning and maintenance

4

Before cleaning the fan, you must switch it off [ 0 ] and remove the plug from the socket.

• Wipe the exterior of the appliance with a slightly damp cloth and dry properly.

• If necessary, you can clean the protective guard using a vacuum cleaner (nozzle).

• Do not use aggressive or abrasive cleaning agents for cleaning the appliance.

• Never submerge the fan in water or any other liquid.

12 • English

Page is loading ...

We do not need to remind you of the importance of service. After all, we develop our products to a standard so that you

can enjoy them for many years, without any concerns. If, nevertheless, there is a problem, we believe you are entitled to a

solution straight away. Hence our products come with an exchange service, on top of the rights and claims you are entitled to

by law. By exchanging a product or part, we save you time, effort and costs.

2-year full manufacturer’s warranty

1. Customers enjoy a 2-year full manufacturer’s warranty on all Inventum products. Within this period, a faulty product or part will

always be exchanged for a new model, free of charge. In order to claim under the 2-year full manufacturer’s warranty, you can either

return the product to the shop you bought it from or contact the Inventum costumer service department via the form at www.

inventum.eu/service-aanvraag.

2. The 2-year warranty period starts from the date the product is bought.

3. In order to claim under the warranty, you must produce a copy of the original receipt.

4. The warranty applies only to normal domestic use of Inventum products within the Netherlands.

Breakdowns or faults outside the warranty period

1. Breakdowns or faults in small or large domestic appliances outside the warranty period, can be reported to the costumer services

department via the form at www.inventum.eu/service-aanvraag or by calling the costumer services department.

2. The costumer services department may ask you to send the product for inspection or repair. The costs of dispatch will be at your

expense.

3. The inspection to establish whether repair is possible involves a charge. You need to grant your permission for this, in advance.

4. In the event of a large domestic appliance, Inventum, at your request, can send out a service engineer. In that case, you will be

charged the call-out costs, as well as parts and labour.

5. In the event of an instruction to repair, the repair costs must be paid in advance. In the event of a repair by a service engineer, the

costs of the repair must be settled with the engineer onsite, preferably by means of PIN payment.

Warranty exclusions

1. The following is excluded from the aforesaid warranties:

• normal wear and tear;

• improper use or misuse;

• insufﬁcient maintenance;

• failure to comply with the operating and maintenance instructions;

• unprofessional installation or repairs by third parties or the customer himself;

• non-original parts used by the customer;

• use for commercial or business purposes;

• removal of the serial number and/or rating label.

2. In addition, the warranty does not apply to normal consumer goods, such as:

• dough hooks, baking tins, (carbon) ﬁlters, etc.;

• batteries, bulbs, carbon ﬁlters, fat ﬁlters etc.;

• external connection cables;

• glass accessories and glass parts such as oven doors;

• and similar items.

3. Transport damage not caused by Inventum is also excluded. Therefore, inspect your new device before starting to use it. If you

detect any damage, you must report this to the store where you purchased the product within 5 working days, or to the Inventum

customer service department via the form at www.inventum.eu/service-aanvraag. If transport damage is not reported within this

period, Inventum does not accept any liability in this respect.

4. The following are excluded from warranty and/or replacement: faults, loss of and damage to the device as a result of an event that

is normally insured under the home contents insurance.

Important to know

1. The replacement or repair of a faulty product, or a part thereof, does not lead to an extension of the original warranty period.

2. If a complaint is unfounded, all costs arising from it will be at the customer’s expense.

3. Following expiry of the warranty period, all costs of repair or replacement, including administration costs, dispatch and call-out

charges, will be charged to the customer.

4. Inventum cannot be held liable for damage caused by external events, unless this liability arises from mandatory statutory

provisions.

5. These warranty and service provisions are governed by Dutch law. Disputes will be settled exclusively by the competent Dutch

court.

general terms and conditions of service and warranty

24 • English

Page is loading ...

VST401W/01.1218V

Wijzigingen en drukfouten voorbehouden/ Änderungen und Druckfehler vorbehalten/

Sous réserve de modiﬁcation / Modiﬁcations and printing errors reserved

Inventum Huishoudelijke

Apparaten B.V.

Meander 901

6825 MH Arnhem

T 0800 -4583688

info@inventum.eu

www.inventum.eu

twitter.com/inventum1908

facebook.com/inventum1908

youtube.com/inventum1908

persoonlijke verzorgingklein huishoudelijk witgoed inbouwwitgoed vrijstaand

Inventum VST401W Owner's manual

This manual is also suitable for

Inventum VST401W Owner's manual

in other languages

Related papers

Other documents