Intertherm E3 Series Electric Furnace Product information

Category
Motorcycle Accessories
Type
Product information
¢710380y¤
WIRING DIAGRAM
Model: E3EH-010H
Notes :
See unit data label for
recommended supply wire sizes.
Thermostat anticipator setting :
0.20 Amps
To change blower speed on units
without a relay box installed refer
to installation instructions
Refer to furnace and/or relay box
installation instructions for
thermostat connections.
If any wire in this unit is to be
replaced it must be replaced with
105 C thermoplastic copper wire
of the same gauge.
Not suitable for use on systems
exceeding 120V to ground.
This wire is used with some
accessories. See accessory
Installation Instructions for further
detail.
Refer to Installation Instructions
for complete wiring diagram.
1)
2)
3)
4)
5)
6)
7)
8)
Optional 4-Speed
Blower
!
WARNING
Switch circuit breakers to the “off”
position before servicing the furnace.
240V
Transformer
Cont
1
24V
Red Pig-Tail
White Pig-Tail
710380A (Replaces 7103800)
IFM = Fan Motor
CB = Circuit Breaker
E = Heater Element
IFS = Fan Switch
Cont = Contactor
LS = Limit Switch
= Fan Plug
Legend:
Cont 1
C
L
IFM
CB-A
CB-A
IFS
LS
Btm - 10.0
6
H
1
2
3
4
5
Red
Blue
Black
E
Cont 1
IFS
Yellow
Grey
Org.
(See Note 7)
Grey Pig-Tail
Fuse
  • Page 1 1

Intertherm E3 Series Electric Furnace Product information

Category
Motorcycle Accessories
Type
Product information

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI