Metropolitan N6862-278 User manual

Metropolitan
Brand
Metropolitan
Model
N6862-278
Type
User manual

This manual is also suitable for

Metropolitan N6862-278

Metropolitan N6862-278 is a lighting fixture designed for indoor use. It comes with a mounting strap, two fixture screws, and decorative nuts for easy installation. The fixture can be adjusted to the desired hanging height using the included thread rods. It features a swivel and canopy for added flexibility in positioning. The fixture's ground wire can be connected to the outlet box's ground wire or directly to the mounting strap using the provided green screw. The fixture can accommodate multiple light bulbs, but the maximum wattage rating should not be exceeded.

Metropolitan N6862-278

Metropolitan N6862-278 is a lighting fixture designed for indoor use. It comes with a mounting strap, two fixture screws, and decorative nuts for easy installation. The fixture can be adjusted to the desired hanging height using the included thread rods. It features a swivel and canopy for added flexibility in positioning. The fixture's ground wire can be connected to the outlet box's ground wire or directly to the mounting strap using the provided green screw. The fixture can accommodate multiple light bulbs, but the maximum wattage rating should not be exceeded.

3
2
1
6pcs
36pcs
1pc
4
6pcs
1
4pcs
2
8pcs
INSTALLATION INSTRUCTIONS
Item #N6869-278 (03/06/2014)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig.1
Fig.2
Fig.3
PREPARING THE FIXTURE (Fig.2)
1. Shut off the power at the fuse box or circuit
breaker. If necessary, remove the existing fixture
and its mounting hardware from the ceiling.
2. Carefully remove the new fixture from the carton
and check that all parts are included as shown in
the illustration.
3. Determine the desired hanging height and
thread rods (A) into the top of the fixture body.
4. Carefully pass the fixture wires through the rods
as you assemble and pull tight.
5. Pass the wires through the swivel and canopy
and pull tight. Then thread the swivel onto the
rods (A).
MOUNTING THE FIXTURE (Fig. 1)
6. Thread the two fixture screws into the mounting
strap spaced the same distance apart as the
holes in the canopy.
7. Attach the mounting strap to the outlet box using
the box screws (Size: #8-32*1.25L). The side of
the mounting strap marked “GND” must face
out.
CONNECTING THE WIRES (Fig. 3)
8. At this point, connect the electrical wires as
shown in Fig. 3, making sure that all wire
connectors are secured. If your outlet box has a
ground wire (green or bare copper), connect the
fixture’s ground wire to it. Otherwise, connect
the fixture’s ground wire directly to the mounting
strap using the green screw provided. After the
wires are connected, tuck them carefully inside
the outlet box.
FINISHING THE INSTALLATION (Fig. 1 and 2)
9. Place the fixture canopy over the two fixture
screws and secure with decorative nuts.
10. Hang the crystal strands onto the fixture body.
11. Install the light bulb (s) in accordance with the
fixture’s specifications. (DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!) (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
Your installation is now complete. Return power to
the outlet box and test the fixture.
Note: Illustration on this manual is for
installation purposes only. It may or may not
be identical to the fixture purchased.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
Set A-012
-Mounting plate
-Ground screw
-Mounting screws (2)
  • Page 1 1

Metropolitan N6862-278 User manual

Metropolitan
Brand
Metropolitan
Model
N6862-278
Type
User manual
This manual is also suitable for

Metropolitan N6862-278

Metropolitan N6862-278 is a lighting fixture designed for indoor use. It comes with a mounting strap, two fixture screws, and decorative nuts for easy installation. The fixture can be adjusted to the desired hanging height using the included thread rods. It features a swivel and canopy for added flexibility in positioning. The fixture's ground wire can be connected to the outlet box's ground wire or directly to the mounting strap using the provided green screw. The fixture can accommodate multiple light bulbs, but the maximum wattage rating should not be exceeded.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents