CTC Union IPCAM-8309FW User manual

Category
Security cameras
Type
User manual
IPCAM-8309FW
Wireless Dual Stream Network Camera
3
LEGAL
The information in this publication has been carefully checked and is believed to be
entirely accurate at the time of publication. CTC Union Technologies assumes no
responsibility, however, for possible errors or omissions, or for any consequences
resulting from the use of the information contained herein. CTC Union Technologies
reserves the right to make changes in its products or product specifications with the
intent to improve function or design at any time and without notice and is not required to
update this documentation to reflect such changes.
CTC Union Technologies makes no warranty, representation, or guarantee regarding the
suitability of its products for any particular purpose, nor does CTC Union assume any
liability arising out of the application or use of any product and specifically disclaims any
and all liability, including without limitation any consequential or incidental damages.
CTC Union products are not designed, intended, or authorized for use in systems or
applications intended to support or sustain life, or for any other application in which the
failure of the product could create a situation where personal injury or death may occur.
Should the Buyer purchase or use a CTC Union product for any such unintended or
unauthorized application, the Buyer shall indemnify and hold CTC Union Technologies
and its officers, employees, subsidiaries, affiliates, and distributors harmless against all
claims, costs, damages, expenses, and reasonable attorney fees arising out of, either
directly or indirectly, any claim of personal injury or death that may be associated with
such unintended or unauthorized use, even if such claim alleges that CTC Union
Technologies was negligent regarding the design or manufacture of said product.
TRADEMARKS
Microsoft is a registered trademark of Microsoft Corp.
Please check CTC Union's website for any updated manual or contact us by E-mail at
[email protected]. Please address any comments for improving this manual or to point out
omissions or errors to [email protected]. Thank you.
CTC Union maintains a support web site (support.ctcu.com) where you may obtain the
latest manual, quick installation guide, and operational firmware. Membership to this web
site is free, however, you must be a registered member in order to access any software
updates.
CTC Union Technologies Co., Ltd.
2008~2009 Copyright, All rights reserved.
4
Table of contents
1.
INSTALLATION & PRODUCT SPEC.......................................................... 6
2. USING IP CAMERA VIA MOBILE PHONE OR MEDIA PLAYER............... 9
3. SETTING UP WIRELESS CONFIGURATION .......................................... 10
4. HOW TO USE INTELLIGENT IP INSTALLER.......................................... 12
4.1. Initial use Intelligent IP Installer ...........................................................................12
4.2. Configuration of Main Menu.................................................................................13
4.3. Camera................................................................................................................14
4.3.1. Setup...................................................................................................................................15
4.3.2. Upgrade..............................................................................................................................22
4.3.3. Factory Default....................................................................................................................23
4.3.4. Reboot.................................................................................................................................24
4.4. User.....................................................................................................................25
4.4.1. Info......................................................................................................................................28
4.4.2. User.....................................................................................................................................29
4.4.3. Date/Time............................................................................................................................30
4.4.4. TCP/IP.................................................................................................................................31
4.4.5. PPPoE.................................................................................................................................32
4.4.6. DDNS..................................................................................................................................33
4.5. About...................................................................................................................34
5. USING IP CAMERA VIA WEB BROWSER .............................................. 35
6. CONFIGURATION .................................................................................... 36
6.1. Initially accessing the IPCAM...............................................................................37
6.2. Configuration of Main Screen ..............................................................................38
6.2.1. Setting.................................................................................................................................38
6.2.2. Client Setting.......................................................................................................................38
6.2.3. Image Setup........................................................................................................................39
6.2.4. Live View.............................................................................................................................40
6.3. Basic Setting........................................................................................................41
6.3.1. System................................................................................................................................41
6.3.1.1. Information..........................................................................................................41
6.3.1.2. Date & Time Setting............................................................................................42
6.3.1.3. Initialization.........................................................................................................44
6.3.2. Camera...............................................................................................................................45
6.3.2.1. General...............................................................................................................45
5
6.3.2.2.
MPEG-4..............................................................................................................46
6.3.2.3. M-JPEG..............................................................................................................49
6.3.3. Network...............................................................................................................................50
6.3.3.1. Information..........................................................................................................50
6.3.3.2. PPPoE................................................................................................................51
6.3.3.3. DDNS..................................................................................................................52
6.3.3.4. UPnP ..................................................................................................................53
6.3.3.5. IP Notification .....................................................................................................54
6.3.4. Security...............................................................................................................................56
6.3.4.1. Accounts.............................................................................................................56
6.3.4.2. HTTPS................................................................................................................57
6.4. Advanced Settings...............................................................................................58
6.4.1. FTP Client...........................................................................................................................58
6.4.1.1. General...............................................................................................................58
6.4.1.2. Alarm Sending....................................................................................................59
6.4.1.3. Periodical Sending..............................................................................................61
6.4.2. SMTP..................................................................................................................................62
6.4.2.1. General...............................................................................................................62
6.4.2.2. Alarm Sending....................................................................................................64
6.4.2.3. Periodical Sending..............................................................................................66
6.4.3. HTTP Event.........................................................................................................................67
6.4.3.1. General...............................................................................................................67
6.4.3.2. Alarm sending.....................................................................................................68
6.4.4. Schedule.............................................................................................................................69
6.4.5. Motion Detection.................................................................................................................70
6.4.6. System Log.........................................................................................................................72
1. Installation & Product SPEC
Installation Steps
Follow these steps to install the CTC Union IPCAM-8309FW on your LAN:
1. Check the package contents against the list below.
2. Setup the device. See Chapter 3.1 on the available methods
Package Contents
Video Server CTC Union IPCAM-8309FW Network camera
Power Adapter Country-specific
CD User manual Documents
Camera Stand Supplied with mounting screws
Overview
Front Panel
Focus Adjustment Ring: Adjust the focus ring to get a clear image.
6
Rear Panel
Reset: When the device is powered, press the Reset Button to reboot the device, or
hold the Reset Button for 10 seconds to set the settings back to factory default.
7
8
Product Specification
9
2. Using IP Camera via Mobile Phone or Media
Player
To use IP cameras via mobile phones, please make sure your RTSP is set to “ON”.
(Default is “ON”) To change the settings of IP cameras, please see “Settings” for details.
3G Mobile Phone viewing
For 3G mobile phone viewing, type “rtsp://<IP>:<PORT>/video.3gp” into your 3G web
browser. <IP> is the IP address of your IP camera, <PORT> is the RTSP port of your IP
camera (Default value is 8554.)
Example: rtsp://100.10.10.1:8554/video.3gp
Note:
You can also use RTSP clients (RealPlayer, Quicktime…etc.) to view RTSP streaming,
just type in “rtsp://<IP>:<PORT>/video.3gp” as the Player’s URL
2.5G Mobile Phone viewing
For 2.5G mobile phone viewing, type “<IP>/mobile.wml” into your 2.5G web browser.
<IP> is the IP address of your IP camera.
Computer viewing
You can also use RTSP clients (RealPlayer, Quicktime…etc.) to view RTSP streaming,
just type in “rtsp://<IP>:<PORT>/video.mp4” as the Player’s URL.
3. Setting up Wireless Configuration
This chapter describes how to set up the camera’s wireless connection. The wireless
connection has to be set up using network cable connection. After correctly setting the
camera, the wireless function can work without network cable connection.
1. Connect to the IP Camera using network cable connection. Enter the configuration
page (See “Network” chapter for details.)
2. Go “Settings -> Basic -> Network -> Wireless”, set the Wireless option to “On”, then
click on “Refresh”.
3. Choose the wireless AP you wish to connect, enter password if needed. (If you don’t
know the settings of the wireless AP, please ask your network administrator.)
4. If you’re using DHCP, the new IP address will show up after wireless setup succeeds.
10
11
4. How to Use Intelligent IP Installer
This chapter introduces how to monitor the image from the camera using Intelligent IP
Installer. The IP cameras can be used with Microsoft web browsers and Intelligent IP
Installer in Windows operating systems. This document focuses on introducing you to
Intelligent IP Installer. If you want to know how to use IP cameras with Microsoft web
browsers, please check the camera user manuals.
4.1. Initial use Intelligent IP Installer
1. Install the program of Intelligent IP Installer.
Note:
• If you’re using Windows 98 or ME, please install IP Installer before using WEB UI to
ensure the system runs normally.
• If you can’t view the recorded video file (missing video decoder), please install Xvid
codec while installing Intelligent IP Installer. (For Windows 98, ME or 2000 server, the
codec might not work properly. You’ll need to download Xvid codec 1.0 from the
internet.)
2. Click Start -> Program Files ->CTCU-> Intelligent IP Installer -> Intelligent IP Installer
to start using the program.
12
4.2. Configuration of Main Menu
Main Menu
Camera
Click this button to get into common information of all Network Cameras in local
network. You can connect the specific Network Cameras to get live video and to
optimize video setting.
User
Click this button to get into user basic setting information of all Network Cameras in
network. You can connect the specific Network Cameras to get and set basic values.
This section includes Info, User, Date Time, TCP/IP, PPPoE and DDNS.
Note:
• Only the administrator has access to the Settings.
About
Click this button to get the information of Intelligent IP Installer.
13
4.3. Camera
The Camera page provides you all Network Cameras in the network with product
factory information, including product Name, IP Address, MAC, Mod. Name and Mod.
ID.
SearchClick it to search Network Cameras in the network, it displays Network
Cameras information including Name, IP Address, MAC, Mod. Name and Mod. ID.
Note:
If the camera is not located in local network, it will appear in red text. Some
information is not available when the IP camera is not in local network.
The IP addresses shown in the "IP Address" field reflect those on the local network.
They may be from the DHCP server. If there is no DHCP server, the IP Camera will
try to find a free IP address (this takes from 15 second to 3 minutes, depending on
the LAN status). The method of finding IP address is seeking from 192.168.1.2, to
192.168.1.254. If any of the address inside this range is free, the Network IP
Camera will be assigned to this IP address, and its subnet mask would be
255.255.255.0.
Link to IEAfter searching Network Cameras in network, you can click to specific
Network
Cameras in search area and press Link to IE to use IP cameras with
Microsoft web browses.
14
4.3.1. Setup
Choose a network camera, click on Setup to change the
configurations. You have to key in the username and password of the
administrator to enter the setup page.
The following screen will display:
Note:
For IP cameras not in local network area (which appears in red in the search
screen), you can still use setup to change the configurations of these cameras.
System Information: The system information is displayed.
Press “Next” to continue, “Previous” to go back, “Cancel” to go to the main page.
15
Account settings: The account setting is displayed. You can change the
account setting here.
Press “Next” to continue, “Previous” to go back, “Cancel” to go to the main page.
16
Date/Time settings: You can set the date/time of the network camera here.
See ”Hint” for details.
Press “Next” to continue, “Previous” to go back, “Cancel” to go to the main page.
17
Network settings: You can change the network settings of the network camera
here. See “Hint” for details.
Press “Next” to continue, “Previous” to go back, “Cancel” to go to the main page.
18
PPPoE settings: You can change the PPPoE settings here. See “Hint” for details.
Press “Next” to continue, “Previous” to go back, “Cancel” to go to the main page.
19
DDNS settings: You can change the DDNS settings here.
Press “Next” to continue, “Previous” to go back, “Cancel” to go to the main page.
20
Apply settings: Click on “Apply” to use the new settings.
Choose “Reboot system to apply new (network) settings” to reboot after the
settings are applied.
21
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40
  • Page 41 41
  • Page 42 42
  • Page 43 43
  • Page 44 44
  • Page 45 45
  • Page 46 46
  • Page 47 47
  • Page 48 48
  • Page 49 49
  • Page 50 50
  • Page 51 51
  • Page 52 52
  • Page 53 53
  • Page 54 54
  • Page 55 55
  • Page 56 56
  • Page 57 57
  • Page 58 58
  • Page 59 59
  • Page 60 60
  • Page 61 61
  • Page 62 62
  • Page 63 63
  • Page 64 64
  • Page 65 65
  • Page 66 66
  • Page 67 67
  • Page 68 68
  • Page 69 69
  • Page 70 70
  • Page 71 71
  • Page 72 72

CTC Union IPCAM-8309FW User manual

Category
Security cameras
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI