Dynex DX-AC501 Quick setup guide

Type
Quick setup guide

This manual is also suitable for

DX-AC501
500mA Universal AC Adapter
This adapter is designed to supply power to most small electric
devices. To ensure proper conguration of the adapter for your
device, follow these instructions carefully.
Package contents
500mA universal AC adapter
Six plug tips for most common electric devices
Quick Setup Guide
Getting started
1 Determine the voltage required to power your device and
select the same voltage on the adapter. (Examples include
3V and 4.5V) (You may nd the required voltage beside the
device DC jack.)
2 Locate the DC input on the device (sometimes labeled DC in)
and select the plug that best ts the jack.
3 Determine the polarity required to power the device and
insert the plug into the cable receptacle as follows:
If your device shows a positive polarity symbol on the product,
then insert the plug like this:
QUICK SETUP GUIDE
Note the positive (+) symbol on the plug.
Note the word “TIP” is visible.
4 Connect the adapter to an AC power outlet and operate
the device according to the manufacturer’s instructions.
Cautions
Unplug the adapter before selecting a new DC output
voltage. Failure to do so may damage the device.
The adapter emits heat when operating at its maximum
capacity for an extended period of time. Handle it with
care when it’s hot.
Specications
Model: DX-AC501
Input: 100-240V AC 50-60Hz
Output: 3/4.5/6/7.5/9/12V DC 500mA
Operating temperature: 0°C ~ 40°C
Storage temperature: -10°C ~ 70°C
Relative humidity: 10% ~ 90%
Cable length: Approximately 6 ft. (1.83 m)
Housing: PC (Plastic)
Safety requirement: FCC, ICES-003
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction, maybe cause harmful interference to radio
communications. However there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian ICES‐003;
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
One-year limited warranty
Visit www.dynexproducts.com for details.
© 2011 BBY Solutions, Inc. All Rights Reserved.
DYNEX is a trademark of BBY Solutions, Inc. Registered in some countries. All other
products and brand names are trademarks of their respective owners.
ENGLISH 11-0887
  • Page 1 1
  • Page 2 2

Dynex DX-AC501 Quick setup guide

Type
Quick setup guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI